2539104583 Kenmore Freezer - Overview
Sections of the 2539104583
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Refrigerator Light Bulb
PartSelect #: PS12712277
Manufacturer #: 5304517886
This 3.8-watt LED light bulb is designed to illuminate the interior of select refrigerator models, providing bright and efficient lighting when the door is opened. If your current bulb is dim, flicker...
$86.25
In Stock
Hinge Kit
PartSelect #: PS2581693
Manufacturer #: 297321900
This freezer door hinge assembly supports the door and allows it to open and close smoothly while helping maintain a proper seal. It provides the stability needed to keep cold air inside and food stor...
$103.53
In Stock
Gasket Retainer Clip Kit - 24 Pieces
PartSelect #: PS469567
Manufacturer #: 5303922007
These are used to hold your gasket in place.
$84.63
Special Order
Filter - Drier
PartSelect #: PS464532
Manufacturer #: 5303305677
Refrigerant system filter/dryer.
$41.40
In Stock
Overload Protector
PartSelect #: PS459235
Manufacturer #: 5303276514
This part provides protection for the compressor motor against excessive current and excessive temperature use.
No Longer Available
Questions And Answers for 2539104583
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the 2539104583
[Viewing 5 of 5]Frost buildup
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Fridge too warm
Fixed by
these parts
these parts
Show All
Freezer section too warm
Fixed by
these parts
these parts
Show All
Won’t start
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Clicking sound then within a minute clicking again, not cooling.
UNPLUG REFRIGERATOR. Carefully remove relay from the side of the compressor. You shouldn't need a tool to do this, if it is hard you can gently pry the edge with a flat head screw driver just to loosen. Unplug white and red wires from relay, noting that the white wire goes in the hole with a #2 stamped beside it. Shake old relay, if it rattles like a baby rattler then it's most likely the problem. Replace wires into the new relay and plug back into the compressor.
Parts Used:
-
Melvin from Semmes, AL
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
81 of 97 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Stopped working, cooling.
I used a small screwdriver to disconnect wires from old starter. I connected the overload and starter, two wires. I put the unit back in the keeper, plugged the unit in, turned up the thermostat and it's working beautifully.
Parts Used:
-
Jennifer from Jonestown, TX
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
15 of 19 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Freezer quit. Compressor would not start.
Like another post, the start relay rattled like a baby rattle. Replaced the start relay and freezer works great.
Parts Used:
-
Steve from Neosho, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
9 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!