This is a genuine Frigidaire part for your refrigerator. This is an ice maker, which connects to the water lines to provide fresh ice. The most common reason to replace this part is if your refrigerat...
This small but important part helps your fridge defrost safely. It keeps an eye on the temperature of the coils and shuts off the heater when things get warm enough. That way, your fridge doesn’t over...
This center flipper door hinge helps seal the gap between refrigerator doors when closed, ensuring proper alignment and maintaining consistent internal temperatures. By improving the seal, it enhances...
Introducing the Frigidaire Crisper Pan Support for the right side ? an essential part of keeping your refrigerator running at its best. This genuine OEM product is intricately designed to create balan...
This air handler housing ensures proper airflow within your appliance, helping maintain consistent cooling performance. Its sturdy design supports efficient operation and prevents overheating.
Is your refrigerator's crisper drawer wobbly or unreliable? The Frigidaire Crisper Pan Support could be the perfect solution. It authenticates OEM (Original Equipment Manufacturer), which means it's s...
This defrost thermostat kit is an essential component for maintaining proper temperature regulation in your refrigerator or freezer. Designed to monitor the evaporator coil temperature, it prevents ov...
This refrigerator front roller assembly is designed to support the appliance and allow it to move smoothly for cleaning, maintenance, or repositioning. Built from durable metal and heavy-duty plastic,...
$45.61
In Stock
Questions And Answers for 25370319214
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
First I pulled the ice tray out so I could see the solenoid housing/ice tray support(1 unit). Below the ice tray there are 2 screws that hold the solenoid housing/ice tray support. After removing those the assembly lifts up so you can see the wiring harness to disconnect. I pulled it out and removed the 2 screws to open it up. There is 2 screws holding the solenoid in place and one ground wire. This was an easy fix and I know I saved a lot of money.
Simple three steps... 1) There's an front section to the ice-maker to take off. One Phillips screw is on the side, one screw is underneath near the inside of the refrigerator wall. Just unscrew and store. 2) There's a small plastic unit just inside the ice maker to take out. It's held in by a small nut that requires about a 4" extension to reach. (You may be able to unscrew the nut with small needle-nose pliers). Just unscrew and take out the unit - the unit functions just to keep the ice maker wiring in place. 3) The wiring looks a mess, but there's just one wiring connector to the ice maker assembly. Unsnap it. The ice maker is not screwed in, it just slides in -- reach in and pull the assembly straight out; when it stops, lower it a bit and it will come free. Reverse the instructions to install the new unit.
We replaced the damper, but it didn't fix the problem. We then purchased and replaced the thermistor. (We had previously replaced the defrost thermostat). The refrigerator side is now cooling better, but not enough. The damper doesn't seem to be opening. So we have now unplugged the damper and left the opening between the refrigerator propped open and the refrigerator side is now cool enough. (We had previously tried keeping the damper open before we replaced the thermistor and the refrigerator didn't cool off. So the thermistor did fix something, but the damper doesn't seem to have been the problem).
