143033700 Craftsman Engine - Overview

Sections of the 143033700

[Viewing 4 of 4]

Carburetor

Engine

Rewind Starter

Starter 590694 (71/143)

Parts for the 143033700

[Viewing 12 of 137]

O RING-CARB

PartSelect #: PS18504034

Manufacturer #: TC-631028A

It is a genuine manufacturer-approved replacement part that is supplied for use with Craftsman lawn and garden equipment. This gasket is utilized to provide an air-tight seal for the float bowl of a c...

Governor spring

PartSelect #: PS12442627

Manufacturer #: 33578

STARTER DECAL

PartSelect #: PS18544972

Manufacturer #: 36695

Oil Pump Assembly

PartSelect #: PS9935726

Manufacturer #: 29914

Dust Seal Washer

PartSelect #: PS9987011

Manufacturer #: 631184

Nut

PartSelect #: PS11975171

Manufacturer #: 640030

Washer

PartSelect #: PS12450372

Manufacturer #: 37793

Screw

PartSelect #: PS9984857

Manufacturer #: 6021A

Screw (1/4-20x2-9/32)

PartSelect #: PS9988905

Manufacturer #: 650988

This manufacturer-approved screw is supplied directly from the original manufacturer. It is specially made for use with a variety of lawn and garden equipment. The screw is commonly utilized to secure...

Belleville Washer

PartSelect #: PS9988814

Manufacturer #: 650815

Tube

PartSelect #: PS11953280

Manufacturer #: 32447

This is an authentic part that is supplied directly by the original equipment manufacturer for Craftsman engines. The tube vents air from the engine crankcase so it can operate properly. This part is ...

Washer

PartSelect #: PS9934400

Manufacturer #: 28277

Questions And Answers for 143033700

Be the first to ask our experts a question about this model!

Installation Instructions of parts on the 143033700

[Viewing 1 of 1]

Leaking gasoline from carburetor bowl. No air filter

First took photos of the current hookup for referencing. Cleaned the area. Removed the gas tank for easy access to the fasteners and hookups. Everything came undone fairly easy. Cleaned the area some more. Installed all new parts and the form and fit was perfect. Quite the upgrade. Put it all back together. Primed the carb. After about 10 pulls the edger started right up. No gasoline leaks to be found. Shut down. Started on the first pull. I’m good to go.

Parts Used: