143004001 Craftsman Engine - Overview

Sections of the 143004001

[Viewing 4 of 4]

Parts for the 143004001

[Viewing 12 of 154]

ASSM-BELT GUIDE PTO

PartSelect #: PS18444723

Manufacturer #: 40022

O RING-CARB

PartSelect #: PS18504034

Manufacturer #: TC-631028A

It is a genuine manufacturer-approved replacement part that is supplied for use with Craftsman lawn and garden equipment. This gasket is utilized to provide an air-tight seal for the float bowl of a c...

Rod

PartSelect #: PS9940597

Manufacturer #: 31334

Tank Bracket

PartSelect #: PS11954641

Manufacturer #: 35926

STARTER DECAL

PartSelect #: PS18544972

Manufacturer #: 36695

Engine Fuel Line Connector

PartSelect #: PS9987187

Manufacturer #: 632164

Valve Lifter

PartSelect #: PS9932480

Manufacturer #: 27241

Extension Spring

PartSelect #: PS11954258

Manufacturer #: 34593

Screw

PartSelect #: PS9984857

Manufacturer #: 6021A

Screw (1/4-20x2-9/32)

PartSelect #: PS9988905

Manufacturer #: 650988

This manufacturer-approved screw is supplied directly from the original manufacturer. It is specially made for use with a variety of lawn and garden equipment. The screw is commonly utilized to secure...

Belleville Washer

PartSelect #: PS9988814

Manufacturer #: 650815

Tube

PartSelect #: PS11953280

Manufacturer #: 32447

This is an authentic part that is supplied directly by the original equipment manufacturer for Craftsman engines. The tube vents air from the engine crankcase so it can operate properly. This part is ...

Questions And Answers for 143004001

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Installation Instructions of parts on the 143004001

[Viewing 1 of 1]

Leaking gasoline from carburetor bowl. No air filter

First took photos of the current hookup for referencing. Cleaned the area. Removed the gas tank for easy access to the fasteners and hookups. Everything came undone fairly easy. Cleaned the area some more. Installed all new parts and the form and fit was perfect. Quite the upgrade. Put it all back together. Primed the carb. After about 10 pulls the edger started right up. No gasoline leaks to be found. Shut down. Started on the first pull. I’m good to go.

Parts Used: