Lid Hinge Arm - Right Side

Hi Joe, Thank you for your question. If the lid is not closing correctly, the issue could either be the left or right lid hinge or the left or right lid hinge arm. You will need to inspect the parts to see which one is causing the issue. I hope this helps. Thank you and have a great day!

Hi Joe, thank you for your follow up information! That does sound like it could cause an issue. I have linked the left side part down below for you. Good luck with your repair.

Hello Cheryl, thank you for your question. You will need a putty knife and Philips head screwdriver. First unplug your washer. Next raise the whole top so that you can gain access to the screws that hold the hinge in place. Put the putty knife in about three inches from the edge on either side of the front of the washer, and you'll feel a spring clip. Once clips are released, lift the whole top of the washer and hold in place, you will be able to see the screws that hold the hinge in place. unscrew the screws and lower the top assembly, now you can lift the lid with the hinges attached. Simply slide the hinge off the hinge pin. To install the new hinge pin note that there is a locator tab on it that lines up with the smaller hole on the lid to force you to put the pin towards the outside of the lid. Reinstall the Philips screw, but do not over tighten. To reinstall the lid make sure that the locating tabs line up with the holes. Slide those in to place, close the lid and raise the whole top while supporting the lid, then reinstall the screws into the hinge. I hope this helps!