Selector Switch
Fits your WTW4880AW0 Washer!
$130.32
In Stock
Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.
Fits your WTW4880AW0 Washer!
PartSelect Number
PS11752020
Manufacturer Part Number
WPW10285518
Manufactured by
Whirlpool
Troubleshooting
This part works with the following products:
Washer.
This part works with the following products:
Whirlpool, Maytag, Kenmore, Crosley.
Part# WPW10285518 replaces these:
W10285518
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Larry
April 24, 2018
Only getting cold water when set to hot (or any setting). No change in voltage to solenoid hot side with meter, regardless of temp switch setting. Is this the switch being bad? Could it be something else im not checking. Seems switch is stuck on cold only
For model number WTW4800BQ1
Hi Larry,
Thank you for your question. It does sound like it could be the switch that is the issue. You could also take a look at the water going into your appliance from your wall outlet. Just make sure that the problem is not coming from there. I hope that helps. Good luck with your repair.
3 people found this helpful.
Was this helpful?
Thank you for voting!
Pat
December 4, 2019
Centennial washer is leaving clothes soaking wet at the end of the cycle. Machine starts agitating almost as soon as water starts entering at the start of the load. Water is also being added to the machine during the spin cycle. If you run a drain and spin it makes a load whirring sound, but does not seem to actually spin fast enough to wring out the excess water. I have already changed out the belt and cam. Was considering a water sensor level sensor switch and or the to clutch just below the agitator. Any suggestions would be appreciated.
For model number MVWC555DW1
Hi Pat,
Thank you for your question. If your clothes are still wet at the end of a cycle, the issue could be the pump. There may be something it, preventing the water from draining completely. You will need to remove the pump and inspect it to see if this is the issue. If there is no blockage, you should test the pump to see if it has continuity. You will need to test the part with a multi-meter. If the washer is agitating as it is filling with water, it is a washer pressure level issue and you will need to check the tube. I hope this helps. Thank you and have a great day!
1 person found this helpful.
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Sorry, we couldn't find a match for "".
Here's a guide for finding your model number.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11752020
Manufacturer Part Number: WPW10285518
Manufacturer Part Number: WPW10285518
Brand
Model Number
Description