1106509 Kenmore Washer Dryer Combo - Instructions

All Instructions for the 1106509
91 - 105 of 167

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Dryer would not turn on, found metal clip in laundry
0 of 1 people found this instruction helpful.
  • Terry from Carlsbad, CA
  • Easy
  • Less than 15 mins
  • Screw drivers
The dryer door has a switch hidden inside the machine housing. The switch has a lever that protrudes and when the door it closed it hits this lever allowing the dryer to activate.

*** Unplug machine ****

To replace: pulled out the lint trap, remove 2 screws under the lint trap. Pry the top open at the front (it's pre ss fit in place and will pry open with a flat screwdriver).

Lift lid up and prop open (like the hood of a car). Find the switch at the front of the machine just above the drum. Remove 2 screws holding the switch in place (from just inside the drum area). Pull off the broken clip bracket, replace with new one and screw it back into place. Be careful not to drop the screws or bracket or they will fall into the bottom and you may never see them again. I can't stress this enough!!

Let the lid down and give it a good rap on the front to seat it back into place, replace the 2 screws under the lint trap. Replace the lint trap. And your done.
Was this helpful?
Thank you for voting!
replace the latch
0 of 1 people found this instruction helpful.
  • Dennis from Perkasie, PA
  • Really Easy
  • Less than 15 mins
  • Pliers, Screw drivers
take the old latch out and pop the new one in. Your repair kit worked perfect.
Was this helpful?
Thank you for voting!
Wife pulled bed sheets out of drier and broke door switch actuator
0 of 1 people found this instruction helpful.
  • Ernest from Moundsville, WV
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Loosened two screws in back top of drier and pulled forward and up to hinge top of drier and allow access to door switch.Took out broken actuator spring and replaced with new one,snapped lid back in place and put screws back in hinges and job was done.
Was this helpful?
Thank you for voting!
My dryer door would not stay shut.
0 of 1 people found this instruction helpful.
  • Michelle from Colby, KS
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I removed the old door catch by using a screwdriver to pry it out, then I popped the new door catch in its place and it snapped right in. It took less than 5 minutes to do the whole job.
Was this helpful?
Thank you for voting!
the door switch broke, and I had to pop the lid unscrew the switch and use a clothespin to depress the switch acuator button....not pretty.
0 of 1 people found this instruction helpful.
  • Greg from Phoenixville, PA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
same as I described above. However i was amazed when the part showed up the very next day...I was expecting maybe 3 or so days later. I wiil absolutely use PartSelect in the future.
Was this helpful?
Thank you for voting!
Door would not latch
0 of 1 people found this instruction helpful.
  • Richard from Millinocket, ME
  • Really Easy
  • Less than 15 mins
  • Pliers
I pulled the old latch out of the catch and installed a new one. It just popped into place. The job could not have been easier.
Was this helpful?
Thank you for voting!
Couldnt get the dryer to turn on even when i had power.
0 of 1 people found this instruction helpful.
  • Kevin from Tonica, IL
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Very easy to repair remove top of dryer and took out to screws and put switch back in place replaced screws and put top back on. Easy!!
Was this helpful?
Thank you for voting!
Door latch broken
0 of 1 people found this instruction helpful.
  • P from Melbourne Beach, FL
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Repair was straight forward with only two screws to undo. Popped the two sides in and I was done. What was amazing was the lowest cost on parts and the timely delivery.
Was this helpful?
Thank you for voting!
Plastic door latch was cracked.
0 of 1 people found this instruction helpful.
  • David from Kohler, WI
  • Really Easy
  • Less than 15 mins
  • Pliers, Screw drivers
I removed the plastic latch using a screw driver to pry it out. I had to use pliers to completely remove it. Then I snapped the new piece in. It worked perfectly the first time. Very easy repair.
Was this helpful?
Thank you for voting!
broken door catch. door wont close properly
0 of 1 people found this instruction helpful.
  • juan from los angeles, CA
  • Easy
  • Less than 15 mins
  • Screw drivers
i watched the video from Part Select. did exactly as seen and presto it was easily done. never could've done it without Part Select.
Was this helpful?
Thank you for voting!
Part of the dryer door latch fell out and was lost. Needed to replace it.
0 of 1 people found this instruction helpful.
  • William from Alpharetta, GA
  • Really Easy
  • Less than 15 mins
When I ordered the part, I viewed the installation video. That was a key step for me. It told me how to identify the correct part (there are multiple latch pieces in the repair kit, and one of them matches the type of door for the dryer), and how to disassemble the door to get the part installed. When the part came and I installed it, it turned out that I could snap the part in by hand, with no tools. It took about 5 seconds to try it, and it worked.
Was this helpful?
Thank you for voting!
Dryer would not start
0 of 1 people found this instruction helpful.
  • Tim from Pepperell, MA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
The dryer just stopped after a new load of clothes was put in. It appeared to be a power problem as there were not warnings, it just stopped. After checking the power, I suspected it was an electrical interlock problem. After nosing around, I traced the power to the dryer door interlock. Sure enough the switch was fine, but the mechan ical lever was worn away. After Googling around for a replacement I found PartSelect.Com. Found the part, ordered it, and I am back in business. My wife is not happy though, as she wanted a new dryer:)
Was this helpful?
Thank you for voting!
Dryer won't start!
0 of 1 people found this instruction helpful.
  • Richard from Paradis, LA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Googled dryer won't start! From information on the Parts Select website, I determined it was possibly the dryer door switch. Checked the dryer to confirm status of door switch and found it broken! Ordered part and received it within 2 days (actually ordered on a Sunday and it shipped on Monday with receipt on Wednesday. Unpluged the drye r. Used information from Parts select website to remove two screws from vent filter, used screwdriver to pop the top of dryer at each front corner, removed two long screws from the old switch and replaced the broken actuator on the switch with the new actuator received from Parts Select. Note: It was easier to remove old switch with the wires removed from terminals (just pull off), replacing the wires after securing the switch and actuator back in place. Piece of cake, wife happy, received her king of the roost reward :>)) This is also a good time to clean the lint filter area and the hoses to prevent one of those 16,000 annual dryer fires!!!
Was this helpful?
Thank you for voting!
the door catch was broken and I was using duct tape to close the dryer!!
0 of 1 people found this instruction helpful.
  • margery from Lake Spivey, GA
  • Really Easy
  • Less than 15 mins
  • Pliers
This was a classic easy repair and I am sure saved us bundles on a service call.
Was this helpful?
Thank you for voting!
Door would not latch closed when shut
0 of 1 people found this instruction helpful.
  • Carl from Port Arthur, TX
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Reviewed the video showing how to remove the bad-order part and install the new part. No problem. Installing the new part was exactly what was shown in the video on the web page.
Was this helpful?
Thank you for voting!
All Instructions for the 1106509
91 - 105 of 167