CS30 - Parts
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Ignition Module
Part #850108002
This is a genuine OEM sourced replacement part designed for use with gas powered string trimmers and blowers. The ignition module also known as armature-magneto provides current for the ignition system by producing pulses of high voltage for the spark plugs. It is made out of metal with some plastic components and it is sold individually....Read more Includes a spark plug boot. To complete this repair you would need screwdriver set. Please note replacing this module would differ based on your unit, however the basic steps would be the same. • Remove the housing/covers from the unit • Remove the spark plug • Bind the cylinder • Remove the air filter cover and side cover • Remove the throttle cable from the carburetor • Disconnect the wires • Remove old ignition coil • Install new ignition coil • Install the red wire • Set the gap • Install the black wire • Reassembly and test the unit
Read less
Rope-Starter
Part #9789904
Starter Housing W/Eyelet
Part #PA01641
Spring
Part #984106001
Heat Shield (Cat.)
Part #984743001
Intake Gasket
Part #984762001
This is a high quality OEM sourced replacement part that is utilized with Homelite and Ryobi string trimmers. It is the intake gasket that helps to create an air-tight seal, please make sure to check appropriate diagrams for correct location and use of this item. Over time gaskets tend to deteriorate and crack eventually requiring replacement.
Rear Housing
Part #984829001
This is an authentic Ryobi replacement part that has been sourced from the original manufacturer to be used with string trimmers. The durable plastic housing is used to cover and protect the back end of the motor assembly. This item is available as an individual replacement part, please note a Torx dirver is needed to install this part.
Baffle
Part #984837001
This is an authentic replacement part sourced directly from the manufacturer. The baffle is commonly found in Ryobi trimmers, brushcutters, and pruners. This part is made of metal, and is placed in the starter assembly to help hold the starter pulley and to redirect the flow of air. You may require an Allen wrench or hex key when replacing this item. The baffle is provided as an individual replacement part.
Short Block Assembly
Part #984867001
Handle Assembly (W/Out Screws)
Part #985382001
This is an OEM replacement part directly sourced from the manufacturer. It is made of high-quality plastic, and is compatible with many Ryobi string trimmers and brush cutters. Secured to the drive shaft housing and engine, the handle gives the user quick access to the throttle trigger. This item is sold individually, and a screwdriver is needed to make the replacement. Screws sold separately.
Starting Label
Part #985592001
This is an authentic Ryobi replacement part. The starting label is commonly found on Ryobi yard tools such as trimmers and brushcutters. This part is a paper label with adhesive backing, and is placed on the machine housing to give the user instructions on starting the machine. No tools are required when replacing this item. Simply re...Read moremove the old label, peel the new label off of the protective backing, and stick it in place. This item is sold individually.
Read less
Choke Label
Part #985593001