CS30 - Parts
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Air Box Cover
Part #518777001
This is a genuine OEM approved replacement part designed for use with Ryobi trimmers and pruners. The purpose of an air box cover is to secure and protect an air filter. It is made out of black plastic and it is sold individually. This cover snaps into slots of the housing, no tools are needed to replace this cover.
"J" Handle And Grip (BC)
Part #A08130
Gasket
Part #5945603
Genuine OEM replacement part this item is sold individually. This part acts as seal to keep debris from entering the carburetor and engine. It is installed in between the carburetor gasket and the heat shield on the outdoor products listed below.
Rear Handle
Part #570234002
Bumper
Part #570549001
This authentic item is supplied directly from the original equipment manufacturer for use with Ryobi, Homelite and Ridgid handheld lawn and garden equipment. It is an identical replacement for a missing or a damaged bumper that was installed on a new unit. The part helps to secure the fuel tank in the housing. Make sure to check the appro...Read morepriate diagrams for your model for the exact location and the correct application of this component. Keep in mind this high-quality bumper is made of durable material and is sold individually.
Read less
Curved Shaft Assembly
Part #308038010
This is a Genuine OEM sourced replacement part designed for use with Ryobi String Trimmers and Brushcutters. This item is made out of Metal and it is Sold Individually. It is the Lower Shaft that the Cutting Head is attached to. • The attachment connects to the power head by means of a coupler device. • Loosen the knob on the coupler...Read more of the power head shaft and remove the end cap from the attachment. • Push in the button located on the attachment shaft. • Align the button with the guide recess on the power head coupler and slide the two shafts together. • Rotate the attachment shaft until the button locks into the positioning hole. NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place. • Tighten the knob securely.
Read less
Spool And String (.095 In.)
Part #308044008
This item has been sourced from the original manufacturer and is intended to be used with trimmers from Ryobi. The durable plastic spool fits into the cutting head housing and is used to secure the cutting string. The spool retainer secures the spool and can be removed by hand. This item is sold individually.
Carburetor Assembly
Part #308054003
Lock Nut Hx 10-24
Part #81208
This genuine manufacturer-sourced replacement part is specially supplied for use with Homelite and Ryobi handheld lawn and garden equipment. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt, for correct application please refer to appropriate diagrams of your model. This high-quality lock nut is made of durable metal and it is sold individually.
Screw-pan Hd., #8 X 1/2
Part #82348A
Screw (BC)
Part #82496
Connecting Rod Assembly
Part #PA00190