Water Pump
$237.89
In Stock
Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.
PartSelect Number
PS11754310
Manufacturer Part Number
WPW10403802
Manufactured by
Whirlpool
Troubleshooting
This part works with the following products:
Washer.
This part works with the following products:
Maytag, Whirlpool.
Part# WPW10403802 replaces these:
AP6020990, W10403802
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Mike
January 31, 2020
How to replace the pump?
For model number MVW8850YG1
Good Day Mike. Thank you for your question in regards to your unit (Model Number MVW8850YG1). Based on our research, we have found the following information that should assist you with your repair: 1) Before you begin to replace the drain pump in your washer be sure to unplug the power cord and shut off the water supply. 2) Remove the hot and cold water supply lines from the inlet valve. 3) Be prepared for some water to spill out. 4) Release the retaining clamp and detach the drain hose from the outlet hose mounting flange. 5) Now use tape to secure the washer lid. 6) Carefully tip the washer back so it rests on its rear panel. 7) Release the drain pump wire cover. 8) Disconnect the wire connector and unhook the wire from the retaining clip 9) Release the spring clamp securing the hose to the pump and pull off the hose. 10) Use a 5/16 inch socket or nut driver to unthread the drain pump mounting screws. 11) With the screws unthreaded remove the old pump install the new drain pump by positioning it on the tub then thread the screws to secure. 12) Attach the hose to the pump and secure it with the clamp. 13) Connect the wire connector secure the wire under the retaining clip and close the cover. 14) Return the appliance to its upright position. 15) Remove the tape securing the lid attach the drain hose to the outlet hose and secure it with the clamp. 16) Reattach the hot and cold water supply lines with the repair completed. 17) Turn the water supply back on plug the power cord back in and your washer should be ready for use. We also recommend referring to the Owner's Manual of your unit for further information. We hope this helps! Best Regards.
2 people found this helpful.
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Sorry, we couldn't find a match for "".
Here's a guide for finding your model number.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11754310
Manufacturer Part Number: WPW10403802
Manufacturer Part Number: WPW10403802
Brand
Model Number
Description