Models > MAH8700AWW > Instructions

MAH8700AWW Maytag Washer - Instructions

All Instructions for the MAH8700AWW
76 - 79 of 79
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Drain pump
Took back panel off. Replaced the drain pump
Parts Used:
Drain Pump - 120V 60Hz
  • Kimberly from Clinton, MS
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water pump broke
Remove back panel disconnect hoses clamps with hands, use socket wrench on hex bolts, remove pump use philip screw driver. Install new pump same tools, replace panel stated washer, works like new.
Parts Used:
Drain Pump - 120V 60Hz
  • Kermit from Laplace, LA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Washer would not drain nor spin
My husband read on the Internet how common this problem is and how easy we could do it ourselves rather than pay the service etc.... While reading there was a link for Part Select. We simply found the part with-in minutes and ordered. They have PayPal so I basically ordered it in less than 1 minute, emailed my receipt and DONE! We selected overnight shipping because the laundry was piling up - we received the part less than 24 hours and I was up and running before dark! PERFECT!
Parts Used:
Drain Pump - 120V 60Hz
  • Tracy from Danville, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Socket set
Was this instruction helpful to you?
Thank you for voting!
Odd noise when the spin cycle started, water would not drain, D5 error.
The washer comes up with the D5 error if either the door is not shut correctly, or it can not detect that the washer is drained. I had to put the washing machine on its side to access the bottom. There is an access hole that you can get the pump from. I unplugged the pump, then removed the bolts to take it out. The pump comes apart with a few screws removed. I saw that the magnet inside was broken in half. Putting a new pump back in solved the issue.
Parts Used:
Drain Pump - 120V 60Hz
  • Anthony from Holbrook, AZ
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the MAH8700AWW
76 - 79 of 79