DB5710DT Samsung Dishwasher - Instructions

snapped it on to the rack shaft

Remove and replace a washer impeller. Simple

With dishwasher removed from cabinet, I next removed the dishwasher racks and with a large adjustable wrench turned the vent cover (located on side wall) inside the dishwasher counter-clockwise a quarter of a turn or so and removed the vent cover and then air/ water inlet unit from the outside of the machine. I cleaned the unit and washer ... Read more wall area prior to replacing the gasket. Replaced the gasket in the air/water inlet vent and reassembled in reverse order. Entire gasket replacement repair took about 5 minutes or less. Most of the time in this project is spent removing and then replacing the dishwasher in the cabinet cavity. My total project time was about 30 minutes.

Removed the broken wheels. Snapped the new wheels on and replaced the basket

Watched a brief video online at PartSelect site. Video was easy to follow and there were no surprises as I followed the instructions.. I highly recommend the PartSelect company. Herb Wise

Un clip and Slide track end cap off. If necessary, remove broken part. The new part snaps into place. Slide rack out and into the track. Replace end cap.

followed video instructions online.

Manually took the broken ones off , put these on.

Unscrewed 10 torx fasteners.Pulled inner door panel up to gain access to latch. Latch has both micro switches attached. Un plug switches, remove and replace door latch, button up and your done.

rotate clamp and reverse for install

One of the wheels on the upper rack of the dishwasher had cracked, causing the rack to derail if it was pulled too far out. The replacement wheel popped right on (with little encouragement). Very easy.

unclip and slide broken wheel off. Slide new wheel on and clip. Easy as pie!

Used flat screwdriver to remove the end cap from the slide bar and after removing the old wheel which popped right off, the new wheel was popped back into place and slid into the slide rail and the end cap replace.

Install complete latch and handle assembly. Remove panel, disconnect wiring and install the assembly

I just followed another persons directions that was in the system already. He had a great idea by taking the new switches out of the new latch and replacing them with the old ones from the bad latch. The old switches are still good and it made for a simple repair. This way you didn't have to disconnect the wire from the switches and now y ... Read more ou have two new switches on hand. The old switch had a burnt spot on the connector.