CAP2000P-OF (Type 0) Bostitch Compressor - Parts

Genuine Bostitch replacement part, this item is sold individually. This part is installed on top of the piston/connecting rod. Its purpose is to create a seal in the cylinder so that air can be pump into the compressor tank. If this part wears your compressor will not pump the air properly. This is a wear part and it is advised to keep an extra one on hand.

It is a genuine item that is supplied by the original equipment manufacturer for use with Bostitch air compressors. The tap ball valve attaches to the tank and helps to drain water. This part can rust over time and can cause leaks and will need to be replaced. A wrench set and a screwdriver may be needed to help replace this part. This item is available as an individual replacement part.

This is a genuine Bostitch replacement part that has been sourced from the original manufacturer to be used with air compressors. The metal elbow attaches to the cylinder head and is used to link the air tube. This item may require a wrench to install and is sold as an individual replacement part.

This is an authentic OEM part. The 3/8" turning nut is made for use with several compressors, and is sold individually. This component helps to fasten the connection to the pressure switch. You will need an adjustable wrench for the repair.

The connection attaches to the turning nut and the pressure reducer. It is an OEM part sourced directly from the manufacturer and used in compressors made by Bostitch. This item is sold individually and is made of metal. A wrench might be necessary during the installation of this part. It will need to be replaced if it breaks.

It is made of metal and is sold individually. The elbow attaches to the pump. A wrench may be required to replace this part. It will require replacing if it becomes broken. This genuine item is supplied by the original equipment manufacturer for use with Bostitch compressors.

Genuine Bostitch replacement part, this item is sold individually. The purpose of this Belt is to run the compressor, to build up air in the compressor tank. It is attached to the crankshaft and to the shaft of the motor. This is a serpentine belt, meaning it has ridges on the inside of the belt to match up with the parts that drive it. It measures 3/8" wide and approximately 15" in circumference.

This is an authentic Bostitch replacement part manufactured for use with air compressors. The special screw is used to secure the fan to the crankshaft. This screw is sold as an individual replacement part, please see model diagram for associative parts.