CAP2000P-OF (Type 0) Bostitch Compressor - Parts

This part is available as an individual replacement part. The valve plate assembly fits between the cylinder valve gasket and the valve plate gasket. A torx screwdriver might be needed during the installation process. It is made of metal and will require replacing if it breaks. This is a Bostitch replacement part directly sourced from the manufacturer for use in air compressors.

It is a genuine OEM supplied replacement part that is designed for use with Bostitch air compressors. The safety valve is an important component that will prevent the tank from over pressurizing, it is designed to open and relieve excess pressure. Over time, the spring inside this valve can deteriorate, allowing air to escape at too low of a pressure. This high-quality brass safety valve is sold individually.

This pressure switch is a specially designed replacement part made for use with Bostitch air compressors. The purpose of a pressure switch is to control when compressor should start or stop building up pressure. Commonly if your air compressor is not turning off and on at the specified pressure. Replacing pressure switch, usually should r...Read moreesolve the issue. Please note to complete this repair you would need a set of wrenches, nut driver set and a thread-sealing tape. • First make sure to unplug air compressor • Drain the air tank • Remove the tank pressure gauge • Disconnect the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Remove the old pressure switch • Install the new one • Reassemble in reverse order • Test the air compressor

This is a genuine Bostitch replacement part, it is sold individually. The purpose of the AB-9051116 Pressure Reducer is to control the amount of air pressure coming out of the compressor tank. This is helpful when inflating items to specified pressure. Also some pneumatic tools use different air pressure specifications to make them operate properly.

This authentic conrod cover is sourced directly from original equipment manufacturer for Bostitch air compressors. It is secured over the piston seal which is sold separately. Please note one durable metal conrod cover is included per order.

This is a high-quality component which is sourced directly from the original equipment manufacturer for use with Bostitch air compressors. The valve blade is placed in the cylinder head assembly in the valve plates to control the flow of air into and out of the cylinder. Over time it may wear out or get damaged eventually requiring a repl...Read moreacement to keep your equipment performing like new. You may require a screwdriver and a wrench set to perform this repair. Note, the valve blade is sold as an individual part. Check the diagrams for your model to ensure the correct replacement procedure.

This is an authentic Bostitch replacement part manufactured for use with air compressors. The unloader valve relieves compressed air inside the cylinder to enable the pump to restart when the pressure inside the tank drops below the switch setting. A faulty unloader valve may trap compressed air above the piston causing the pump to struggle to restart. This unloader valve is sold as an individual replacement part.

This genuine manufacturer-sourced part is specially designed for use with Bostitch air compressors. The purpose of this gasket is to provide a tight seal for the valve plate, unfortunately, over time it will wear out and it may begin to crack eventually requiring a replacement. Keep in mind this high-quality component is made of durable c...Read moreomposite material and is sold individually. Please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware.

The cylinder barrel goes between the group motor/crankcase and the conrod/piston. This part is priced individually and is an OEM from Bostitch for air compressors. It is made of metal and will need replacing if it breaks. A screwdriver, a wrench set, and an allen wrench may all be needed when replacing this part.