All Installation Instructions for Tappan Microwave Oven Combo 77-498

Drawer Guides Broken

New ones just snapped into place it takes less than a minute

Parts Used:

Front Drawer Glide

Charles from Petersburg, VA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 4 people found this instruction helpful.

Was this instruction helpful to you?

broil element was burned out

took out old element put in new one and oven works as good as new

Parts Used:

Broil Element

Joseph from Jacksonville, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Rear door glides and both broken off completely

Part of one of the glides was still inside the hole so had to use a screwdriver to push it on out and simply put the new glides in both rear holes "very easily". Sure am glad I found this site on line. If anything else goes wrong, I will surely contact this site. Thanks. The speedy service was wonderful too. Got it in two days! Carol A. Lawless

Parts Used:

Rear Drawer Glide

Carol from Crossville, TN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

broken drawer slide clips

Easy peasy! Took all of 2 minutes to replace all four clips. Clips snap in by hand and take a little bit of force to make them seat correctly. These are a frequently-replaced item,so that makes me think they are somewhat fragile. Great prices and quick shipping from PartSelect made this so simple. The local appliance parts dealer wanted $11.00 each for the rear clips! Thanks!

Parts Used:

Rear Drawer Glide

Front Drawer Glide

Richard from Spokane, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

The plastic piece broke and I had to replace it to hold the drawer in place

Snapped in the plastic piece after I actually ordered the right piece....wasn't paying enough attention when ordering and didn't have a book that showed the image so I could make sure....went off the image on your website......which is awesome. Totally my fault. Thank you for your wonderful service.

Parts Used:

Rear Drawer Glide

Carrie from Torrance, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

broked drawer slide

The plastic drawer slide that the lower stove door sits on broke. (one on each side) Remove the old one with a screwdriver and snap in the new one, took 1 minute because I replaced both of them.
Excellent fast delivery. 5 stars !

Parts Used:

Front Drawer Glide

Thomas from Spring Hill, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

light in range control panel/splash guard went out

first I removed the 4 screws holding the cover in place. then I removed the 26" flourescent tube by slowing twisting it free. Then I attemped to buy another one at 6 or 8 stores with no luck. While surfing the web for tappan range replacement bulbs, your web site popped up. Thank god.

Parts Used:

Fluorescent Light Bulb

JACK from PATCHOGUE, NY
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Broken drawer glide

Glide just slipped out and the other in.So pleased at how fast the part arrived!! Less than a week.

Parts Used:

Front Drawer Glide

Pamela from Presho, SD
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

lower drawer drags on floor

remove/pry broken plastic glide from in-side of oven,( wall not drawer ) and install new one.

Parts Used:

Front Drawer Glide

columbus from birmingham, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

part was spected for it's size and wattage for a custom built oven

I made a 4' h 3.5' w and 7.5' long powder / ceramic coat oven capable of 700 degrees f. the elements were chosen due to their size and capabilty. I am useing -5- 2950watt elements split on 2 40 amp 120v coil contactors regulated with a PID and thermocouople.

Parts Used:

Broil Element

jeff from vienna, OH
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours

0 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Control will not work - only clock blinks

Took 3 panels off to get to the electric block. Replaced electrical block and put it back together. Still no change.

Parts Used:

Main Terminal Block Kit

Sue from Lampasas, TX
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Screw drivers

0 of 4 people found this instruction helpful.

Was this instruction helpful to you?

replace a broiler calrod on a tappan oven.

if iever need to do this again i will unplug the stove and take the back off. iwill remove the spade connectors from the back and remove and replace the unit from the front. from the rear i will replace the spade connectors and the insulation . plug in the stove and make sure everything works. unplugthe stove, put on the back,plug in the stove and position it.

Parts Used:

Broil Element