110C6 Kenmore Dryer - Parts
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Push-to-Start Switch
Part #WPW10117655
This dryer start switch is a key component that completes the electrical circuit to initiate the drying cycle. Once a timer setting is selected, pressing and releasing the switch activates the dryer. Installation requires a 1/4-inch nut driver and a flathead screwdriver. To replace, first unplug the appliance, remove the rear panel and th...Read moree old switch, then install the new switch and reattach the panel. For detailed guidance, refer to the manufacturer’s installation manual.
Read less
Lint Filter
Part #W10874409
This lint filter screen has a white handle. This filter collects lint as it passes through the dryer vent.
HEATER ELEMENT SINGLE
Part #WPW10044440
This dryer heating element assembly generates the heat needed for proper drying performance and consistent temperature control. The assembly includes the heating coil housed within a durable metal frame, allowing for reliable heat distribution during operation. Replacing a faulty heating element can resolve issues such as no heat, insuffi...Read morecient heat, or clothes taking too long to dry. This component works in conjunction with the dryer’s safety systems, such as thermal cut-off devices, to help prevent overheating. Installation requires disconnecting power to the appliance, accessing the heating element housing, and securing the assembly in place before restoring operation.
Read less
Seal and Bearing
Part #W11035878
This front panel seal kit doesn't include the plastic retainers, reuse the old retainers. No glue is needed, the seal stretches to fit.
Dryer High Limit Thermostat L29550f
Part #WP3391914
This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.
Dryer Drum Roller Shaft Left Side
Part #WPW10359270
Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.
Start Switch
Part #WPW10446920
The push-to-start switch activates the dryer when pressed and released. Compatible with select dryer models, this part ensures proper functionality. Verify fitment before ordering, as similar parts may have slight variations. Disconnect power before installation and use protective gloves.
Drive Motor with Threaded Shaft - 120V 60Hz
Part #279787
The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.
Side and Bottom Vent Kit
Part #W10470674
This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.