Whirlpool Refrigerator Circuit Boards and Touch Pads

This board will need to be programmed upon installation. The electronic control board is used in refrigerators to monitor and manage the temperature settings, such as cooling or defrosting times. If your fridge or freezer is too warm, too cold, is not defrosting, will not start, and/or runs too long then replacing the control board could solve your appliance problem. The tools needed for this installation project is a small flat blade screwdriver. *Please note: the board will need to be programmed after installation. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.

This eight-hour defrost timer will replace most other defrost timers. This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater. The best way to make sure you get the correct timer for your refrigerator is to conduct a search for your model number. NOTE: The black lead on the defrost timer, will go to terminal number 2.

These boards tells the icemaker when it's full and that it has to dump the ice, and it also tells the icemaker when to refill with water.

The timer will shut off the cooling system of the refrigerator and the defrost heater will turn on.

This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

This part controls the functions of the refrigerator.

This is an inverter board for a compressor.