Part Location Diagram of W10629033 Whirlpool Inverter Board
See part 1 in the diagram
( Grid squares measure 1x1 inch )
Customer Service Representative

Get in touch, we're here to help!

Monday to Saturday
8am - 9pm EST

customerservice@partselect.ca

Inverter Board

★★★★★
★★★★★
1 Review
$394.03
  In Stock

Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.

PartSelect Number PS8760019
Manufacturer Part Number W10629033
Manufactured by Whirlpool
Product Description

Inverter Board Specifications

This is an inverter board for a compressor.
How Buying OEM Parts Can Save You Time and Money

How Buying OEM Parts Can Save You Time and Money

Troubleshooting
This part fixes the following symptoms:
Will Not Start
This part works with the following products:
Refrigerator.
This part works with the following products:
KitchenAid, Whirlpool, Kenmore, Jenn-Air.
Part# W10629033 replaces these:
AP5801669, 2209324, 2221559, 2223385, 2224047, 2304098, 2304175, 2306957, 8201670, W10133449
Back to Top
Customer Reviews
Average Rating:
★★★★★
★★★★★
1 Review
5.0
Filter By Rating:
  • 5 Stars
    1
  • 4 Stars
    0
  • 3 Stars
    0
  • 2 Stars
    0
  • 1 Star
    0
  • 1
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
  • 1
Customer Repair Stories
 Average Repair Rating: 3.3 / 5.0, 2 reviews. What's this?
  • 1
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
no electricity going from inverter to compressor
pulled out inverter box, opened up and located burned components in circuit board. rolled the dice bought new one and installed. the terminal leading from inverter didn't match the terminal coming from the compressor . cut both off and supplied my own junction terminal.
Other Parts Used:
  • s. from fort lauderdale, FL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
42 of 71 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Fridge constantly cycling off/on, beeping
Bi-metal defrost thermostat tested bad, so replaced. To remove back freezer panel on this model, remove top left and right shelf pegs (use a screw driver). This will let back freezer panel slide up and out.

Control board, located in metal box above the inverter board had a bad 200uF electrolytic capacitor (bulging top) and 12v relay. Replaced all 5 electrolytic capacitors on the board and all 4 relays.

Works good.
Other Parts Used:
Bi-Metal Defrost Thermostat
  • Joe from PALO ALTO, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

7 questions answered by our experts.
  • 1
Sort by:
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Donald
January 27, 2020
Hello, We had a power surge which caused my frig to totally lose power. I replaced the circuit board. The lights, fan, and digital display are on but the compressor does not turn on. Do i also need to replace inverter board?
For model number kssp48qkss00
PartSelect logo
Hello and thank you for writing. It certainly sounds like the Inverter board might also have shorted. The easiest way to diagnose which part is faulty is to test the parts with the use of a multimeter. We hope this helps. Please contact us anytime if you require further assistance.

3 people found this helpful.

Was this helpful?
Thank you for voting!
Greg
December 22, 2019
When the inverter board is going bad does it make a clicking or beeping sound and make the condenser fan cycle on and off rapidly. The compressor is running when this happens and doesn't shut down. Also the freezer and refrigerator compartments are cold and the factory temperature settings are reached. ( 0/37 degrees) thanks for your reply
For model number GC5SHEXNS05
PartSelect logo
Hi Greg, I think it may actually be the control board. All the symptoms seems like the control board failing. Thank you for your question and good luck with your repair!

2 people found this helpful.

Was this helpful?
Thank you for voting!
Related Parts:
John
June 5, 2024
Had a power outage and when the power came back 4 hours later on the kitchenaid refrigerator (KBFC42FTS02) was not cooling/freezing. fans are running and controls/lights are fine but compressor not coming on.
For model number KBFC42FTS02
PartSelect logo
Hello John, thank you for getting in touch. We have concluded that the issue is with the inverter board, part number PS8760019. We would recommend checking it to solve the problem. Glad to be of help!

1 person found this helpful.

Was this helpful?
Thank you for voting!
Peter
October 14, 2021
Our freezer seems to get stuck in defrost mode? It runs fine then all the sudden it heats up in the freezer. The only way to get it back cold is to turn off the main power switch (under the top panel) for a few minutes and turn it back on. That usually gets the compressor to start up and start cooling again…. Until tomorrow?
For model number KSSS48QMW00
PartSelect logo
Hello Peter, Thank you for the question. We suggest testing the Defrost Thermostat, PartSelect Number PS11750673. The best way to do this is to remove the thermostat from the refrigerator so you can control the temperature of the sensor. You can let the sensor warm up to room temperature. With the sensor warmed up to room temperature the sensor should read approximately 6.2K Ohms at 68°F. With the thermistor submerged is a glass full of ice water, the sensor should be very close to 32°F which should read approximately 16.3K Ohms. If the values that you are getting are far off from these readings, then the sensor is bad and should be replaced. We hope this helps!

Was this helpful?
Thank you for voting!
Related Parts:
Frank
December 27, 2022
Both freezer and refrigerator are not cooling, despite the fan running continuously. It appears the compressor will not turn on after multiple attempts to power the refrigerator off and on. There is a green flashing light from the control board located to the left of the compressor. My technician suspects a faulty compressor relay after checking it with the voltmeter. Can this be the only issue? And is the relay sold as a separate component or is it bundled with the compressor?
For model number JS48PPDUDB01
PartSelect logo
Hi Frank, thank you for the question. Make sure the condenser coils are not dirty and the evaporator is not frozen over. The issue is most likely related to a faulty start relay (not available separately for your model, so you must replace the inverter board, part number PS8760019). If this does not help, you need to inspect the defrost thermostat, part number PS11749258, and temperature control board. Please reach out to customer service if you need help placing an order. Glad to be of help!

Was this helpful?
Thank you for voting!
Related Parts:
B
September 29, 2023
Does this part include the green LED light that flashes if there is a problem?
For model number KSSS48FMX02
PartSelect logo
Hello B, thank you for reaching out. According to our research, the inverter board that you mentioned does not come with the LED light. We hope this information is useful!

Was this helpful?
Thank you for voting!
Kelton
September 29, 2023
I just had our main circuit controller board refurbished (Core Centric) since they are no longer available on your website. We had is sent in twice. it does not interface with the temperature controls inside the fridge (the buttons that you use to set the temperatures) Set fridge to 34 but it cools to 20 and the freezer set to 0 but cooling to -20. Each time it is doing the same thing. The repair guy told us that it must be the interface board to the main circuit board. They want to charge another 280 for the part. I looked on your site and did not see such an extra interface board. Can you help me understand what additional board this may be? Maybe it is another name but maybe they are trying to get more $ for something they should have already fixed. Thanks
For model number KSSC48QMS01
PartSelect logo
Hi Kelton, thank you for getting in touch. Based on the description that you have provided, we would recommend checking the user control and display board, part number PS11740282, as it is most likely faulty and may need to be replaced. We hope this sorts out your problem!

Was this helpful?
Thank you for voting!
Related Parts:
  • 1
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS8760019
Manufacturer Part Number: W10629033
Brand
Model Number
Description
Kenmore
10641522500
Refrigerator
Kenmore
10641523500
Refrigerator
Kenmore
10641524500
Refrigerator
Kenmore
10641529500
Refrigerator
Kenmore
10644022600
Refrigerator
Kenmore
10644022601
Refrigerator
Kenmore
10644022602
Refrigerator
Kenmore
10644022603
Refrigerator
Kenmore
10644023600
Refrigerator
Kenmore
10644023601
Refrigerator
Kenmore
10644023602
Refrigerator
Kenmore
10644023603
Refrigerator
Kenmore
10644024600
Refrigerator
Kenmore
10644029600
Refrigerator
Kenmore
10644029601
Refrigerator
Kenmore
10644029602
Refrigerator
Kenmore
10644029603
Refrigerator
Kenmore
10644032600
Refrigerator
Kenmore
10644032601
Refrigerator
Kenmore
10644032602
Refrigerator
Kenmore
10644032603
Refrigerator
Kenmore
10644033600
Refrigerator
Kenmore
10644033601
Refrigerator
Kenmore
10644033602
Refrigerator
Kenmore
10644033603
Refrigerator
Kenmore
10644034600
Refrigerator
Kenmore
10644039600
Refrigerator
Kenmore
10644039601
Refrigerator
Kenmore
10644039602
Refrigerator
Kenmore
10644039603
Refrigerator
Customer Service Representative

Get in touch, we're here to help!

Monday to Saturday
8am - 9pm EST

Contact Customer Service