This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part works with the following products:
Dryer, Washer Dryer Combo, Washer.
This part works with the following products:
Frigidaire, Kenmore, Tappan, Kelvinator.
Part# 131062300 replaces these:
AP2105933, 489, 5303285734
Customer Repair Stories
Average Repair Rating: 4.2 / 5.0, 4 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Timer would not shut dryer off.
A few screws out of the back of the top panel, pulled the dial off. Removed two more screws and the timer assembly came off. Then I just matched the color wires one at a time to the same spots on the new assmbly.
Other Parts Used:
Bobby from Blue Ridge, TX
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
16 of 25 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Timer had stripped gears and wouldnt work
unpluged dryer first. Removed knob,rear panel and two screws holding timer in panel. Swaped wires one at a time to new timer and replaced it in dryer.Replaced rear cover and pluged it in and tested the timer .it worked fine so repair complete.
Other Parts Used:
Gene from Hamburg, PA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
8 of 10 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Had to replace the timer assembly.
Remove the two scews that held it in place. Pulled the element out far enough to replace it. I left the old part on so as not to get confused by which wire went where, and just replaced the part. Very easy.
The timing unit on the dryer no longer worked. I ordered a replacement timing unit which arrived in 3 days; followed instructions that came with the washer dryer combo and removed panels, replaced the timing unit and successfully tested. The installation of the replacement part took 35 minutes.
Other Parts Used:
joseph from CORAM, NY
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
7 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Henry
June 24, 2019
Dryer will not start, makes finish alarm sound only. Does this sound like a timer issue? If so, please supply item#.Thank you
For model number FEZ831AS1
Hello Henry, Thank you for the question. If the dryer does not start and the timer knob is not turning like it is going through the cycle, I would recommend replacing the timer switch. hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Tony
September 10, 2019
When replacing the timer on a Kenmore 500, I fit the wires onto the new timer in the exact locations as on the old one. Do the wire connectors have to be turned the same way on the new timer as on the old one? (the wire connectors have open and closed sides). If it matters, how do i correct them? The dryer will not start.
For model number 110.67522600
Hi Tony, the wires are put on the same way the old timer was on. I would check your thermal fuse, make sure the venting system is not clogged with lint, check the door switch, start switch and motor. Thank you for your question and good luck with your repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Richard
August 10, 2021
Will timer stop dryer from starting? It has power to it.
For model number 41798702892
Hello Richard, Thank you for the question. If the Timer is defective it can not start the Cycle, therefore not allowing the Dryer to start. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Steve
September 12, 2017
I have a Frigidaire clothes dryer, model #fde336res2. i'm noticing parts of clothes are frequently getting scorched. The timer knob doesn't advance. the dryer works, but i have to use an external kitchen timer to time the drying. Would the lack of a functioning timer cause scorching?
For model number FDE336RES2
Hello Steve, thank you for contacting us. It does sound like the timer needs to be replaced since it is not advancing properly. This should fix the scorching issue as well. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Steve
October 27, 2017
I had a dryer timer that wasn't advancing. I bought a replacement for the timer and a new knob. The timer advances, but the start stop positions now aren't in sync. With the markings on the dryer. The dryer timer can only be installed in one position. Is there a way to remedy this problem? 1) timer knob for frigidaire dryer part #134011703
2) frigidaire Kenmore dryer timer #131062300
3) frigidaire dryer model number fde336res2
For model number FDE336RES2
Hi Steve,
Thank you for your inquiry. Based on the model number you provided the part number for the correct timer knob for your appliance is PS419211. There is a video listed with the part on our websitet that you may reference on how to install the knob. I hope this helps. Thank you and have a great day!
Was this helpful?
Thank you for voting!
Steve
October 27, 2017
With regard to the dryer knob issue posted a few moments ago, i specifically went to your website last month before i purchased this knob. According to your website, the manufacturer's part number for this knob is: 134011703. That is the one that i purchased and that is noted in my earlier post. The alternative number that you posted is one and the same.
For model number FDE336RES2
Hi Steve,
Thank you for contacting us again. That would be correct. When looking behind your knob, there is a D-shaped hole. The flat side should be pointing downward when you are installing that part. If it is off perhaps either your timer is not in the correct position or the part is defective. I would suggest calling our customer service so that one of our agents can look at your order with you. If your part is defective, we have procedures to help get you a working part. Good luck with your repair.
Was this helpful?
Thank you for voting!
Paul
October 13, 2023
The photos for this part do not match the part from my machine but the part number does. Is this just because the photos are not updated for each part? Can you verify this part will fit my machine?
For model number FLSE60RGS1
Hi Paul, thank you for the question. Based on our research, the part mentioned is the compatible timer for your model. Please contact us anytime if you require further assistance!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This solid element restorer is for ranges and cooktops. Solid element restorer restores and protects solid elements from rusting and spotting. Follow the instructions on the label when using this product.
This low-odor gel, easily cleans away tough burnt-on deposits at room temperature. Apply the gel evenly on the cooled oven surface. Leave the gel to set overnight then wipe away with a clean cloth.
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS416776
Manufacturer Part Number: 131062300
