Air Filter W10120839A

By pulling the filter screens units down and out with a pair of pliers I had access to the surface lights. Pulled the lights out of their sockets and replaced the bulbs. Real easy. Since the filter units were out, replaced the filters and reinstalled the filter units. The whole operation took less than 15 minutes.

The buttons are easy to access. Disconnect the power to the oven then just remove the center grill on top of the microwave then remove the screw attaching the left side grill and remove the grill this will allow access to the upper screw holding the left side panel then open the oven door and use a long slender Torx driver to remove the two screws in the side of the panel then remove the screw holding the left side lamp cover and remove the cover and then remove the left side air intake screen this will allow access to the wiring to the switches and the connector that must be disconnected to allow removal of the side panel, the connector has a small tab that must be depressed to separate the connector, be certain to disconnect the wiring before attempting to remove the side panel as the wiring is too short to allow removal of the side panel while the wiring is connected, after the wiring is disconnected the side panel can be pulled away from the oven it is simply clipped in place and will be removed by pulling it straight toward you after the panel is removed two screws hold the switch circuit board to the side panel, the buttons are part of a fragile plastic tree that is sandwiched between the side panel and the circuit board use care when installing the replacement buttons and circuit board my replacement buttons needed to be reformed by slight hand pressure to make them fit properly. To reassemble just follow the same steps in reverse order. This is a simple operation that can be done in about an hour.

Requires 2 sets of replacement parts. Prior filters included a charcoal filter sandwiched between 2 aluminum filters/screens (3 total parts per side). Replacement charcoal filter was already attached to an aluminum screen so just needed to add 1 aluminum screen/filter so the charcoal was again sandwiched between the 2.

Pulled filter holders out, removed filters, washed holders, installed new filters, and reinstalled assemblies.