Fresh Food Door Gasket

First unload the doors, and remove each door from the fridge and freezer. I placed the doors on the counter island and removed all the screws from around the perimiter with the battery drill. Lots of screws. The freezer door had some Ice accumulated in the insulation inside the door. I salvaged as much of the dry fiberglass and tossed the wet stuff. I cut some strips of fiberglass from a roll of 3.5" I had to replace the tossed insulation. The door seal installation went smoothly and the door rehanging was easy also.

I was able to lay the gasket out flat for about a week. Then installed after removing the old one and the inner part of the door. Getting the small flap that goes behind the edge of the inner door and keeping it in place while reinserting the screws around the edge was the most difficult. It might have been easier wit a magnetic nut driver to start the screws as it was difficult to start the screws when they kept falling.
The gasket fit great and it is a good do it yourself project that will save a lot of money