Models > WRF555SDFZ11 > Instructions

WRF555SDFZ11 Whirlpool Refrigerator - Instructions

All Instructions for the WRF555SDFZ11
31 - 45 of 569
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Pin for lid broke 2 Liter of pop fill on it
Removed drawers and glass top and support bars Two screws on slid bar two screws on end cap, Make sure you take time to remove air control it has two pivot points with small taps.
Then just replace parts as you had taken off very easy.
Parts Used:
Pantry End Cap Kit, LH and RH
  • Tommy N from Tipton, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver
15 of 21 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
spraying water from the connection on top of fridge
just like the video showed, removed the cover parts inside the fridge, disconnected the water tube inside and pulled out from the top of fridge, then inserted new water tube.
Parts Used:
Water Tube
  • Jenny from PHOENIX, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
16 of 25 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Tab on end broke off allow crispers to fall off rail.
lift glass, slide new rail in replace glass. 2 min repair.
Parts Used:
Refrigerator Center Rail
  • Ed from South Lebanon, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
12 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The LH End Cap hinge stud had broken...
Removed the crisper drawers (pull out, then up & out), remove the glass shelf above the "pantry", remove the pantry door (easy because hinge stud was broken), then remove the pantry drawer. Use 1/4" nut driver to remove the broken LH End Cap...it pulls up and out. With the phillips screwdriver, remove/replace the steel rail for the drawer action to the new part. Replace in reverse order (after your neat freak SO cleans everything!).
Parts Used:
Pantry End Cap Kit, LH and RH
  • Myrna from El Paso, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Screw drivers
11 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Light switch in freezer side got broken
Took a putty knife and
Removed the old switch removed the spade terminals from the old switch and replaced them on the new switch and just pushed the new switch back in place
Parts Used:
Door Switch
  • Doug from PLEASANT VIEW, TN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
10 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Main refrigerator light module going bad. Low light.
The new module came all together as one unit. Just needed a small blade flat tip screwdriver to pry the old module out of the fridge. Connected the power strip and the sensor and just pushed the new module back into the slots.
Parts Used:
LED Light Module
  • Oscar from WILSON, NC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
13 of 19 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The bins on the door (ice maker side) became cracked
It was just a simple swap out with the new bins.
Parts Used:
Cantilever Bin
  • Joe from ALTAMONTE SPG, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
11 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Remove the water filter to install the bypass cap
Lower the filter bottom housing to gain access to the filter. Unscrew the filter and install the bypass cap. Secure the lower filter housing to the top assembly.
Parts Used:
Refrigerator Water Filter Bypass
  • Phil from GREENFIELD, IN
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
11 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Cracked plastic on pantry drawer lid
Broken lid popped out, new lid popped in. No tools required. 30 seconds to replace. Great price, part shipped within an hour of placing my order and arrived the next day, although I only paid for standard shipping. Excellent service - will definitely order again if the opportunity arises!
Parts Used:
Refrigerator Pantry Drawer Door Cover
  • Angela from Bay Village, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
10 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Pantry Lid broken, center rail broken, pan corner cracked
Remove broken parts with philips screw driver (6 screws). Replace encaps while attaching pantry drawer lid. Insert center rail and new drawer.
Parts Used:
Pantry End Cap Kit, LH and RH Pantry End Cap Kit, LH and RH Refrigerator Pantry Drawer Door Cover Refrigerator Crisper Pan Refrigerator Center Rail
  • Merrill from Colorado Springs, CO
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
12 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
A friend dropped a jar of relish on the plastic window and cracked it.
Easy repair. Unwrapped the new cover; pulled the old one off by releasing tabs. Inserted new piece.
Took less than 15 minutes. Looks like new. The replacement part arrived quickly from Part Select.
Parts Used:
Refrigerator Pantry Drawer Door Cover
  • Gene from Petaluma, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
9 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken light switch
followed the instructions provided and that's it!
Parts Used:
Door Switch
  • Richard from West Warwick, RI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
12 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken drawer lid
Removed broken lid and snapped new one in place.
Parts Used:
Refrigerator Pantry Drawer Door Cover
  • Rolf from Stanhope, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
8 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Light switch rocker broke, disabling freezer internal light, water dispenser, and ice dispenser
Very simple. Matched female plugs with respective male color coded prong; pushed together then inserted unit in slot of freezer sidewall and rotated into position...job done.
Parts Used:
Door Switch
  • Kenneth from Newton Grove, NC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
10 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Freezer gasket worn out and slightly torn on top.
I pulled the ils gasket out of track and replaced with the new one. Instructions ncluded state to be very careful with new gasket as the magnets may break. Total time 2 minutes with no tools required.
Parts Used:
Freezer Door Gasket
  • William from PRATTVILLE, AL
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
9 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the WRF555SDFZ11
31 - 45 of 569
Back to Top