UT20046 Homelite Trimmer - Parts

The Fuel Tank is an OEM replacement part. It is compatible with the models shown below. It includes the fuel lines, fuel cap and fuel filter. If you need to order the fuel tank bumpers, they are sold individually as part number 98792.

This is an authentic replacement part manufactured for use with Homelite string trimmers. The starter assembly is a complete replacement part including the pulley, spring, rope, handle, and air baffle. This starter assembly is sold as an individual replacement part, please see model diagram for associative parts.

Genuine OEM replacement part, this item is sold individually. This Fuel Cap is is on the fuel tank on the outdoor products shown below. This is a vented Fuel Cap. It includes a gasket inside the Cap.

This item has been OEM sourced to ensure a high-quality standard. The rotor is intended to be used with trimmers, blowers, and chainsaws from Homelite and Ryobi. The rotor is the engine's flywheel and is used as one of the main components in the ignition sequence. The rotor has magnets on its edge that create an electric charge as they pa...Read moress the ignition module, this ignites the air/fuel mixture in the cylinder which rotates the crankshaft and the drive shaft. This item includes the pawls that make contact with the recoil starter pulley when the starter rope is pulled.

It is a genuine manufacturer-sourced replacement part which is supplied for use with Homelite trimmers and blowers. This special piston ring is used to provide an air-tight seal between the piston and the cylinder walls. Over time the ring may begin to wear out allowing combustion gasses to escape, this can result in a significant loss of...Read more power and eventually a no-start condition. It is a high-quality component which is made of durable metal and it is sold individually.

This flanged washer is an OEM sourced replacement part that is made for Ryobi and Homelite handheld string trimmers. The washer has internal gears that allow it to engage with the gear head shaft and the string head adapter. Over time it may wear out, get damaged or lost eventually requiring a replacement to ensure your trimmer operates p...Read moreroperly. It is a high-quality component which is made of a durable metal and is sold as an individual item. Check the owner's manual and the diagrams of your specific model to ensure the correct installation of the new flanged washer. Replacing it is a simple task that should not require any special tools. Remove the string head and the adapter and replace the old washer with the new one.

Genuine OEM replacement part, this part is sold individually. This part is where the stringhead assembly is mounted on the Trimmers shown below. It attaches to the spindle. The thread mount on the spindle is a left hand thread.