UT10927D Homelite Chainsaw - Parts

This is an adjusting pin kit, also known as a chain tensioner kit, for various chainsaw models. This genuine OEM kit features an adjustment/tensioner pin and bar adjustment screw to modify and change the tension of the chain, so when the chain becomes loose over time, you can tighten or loosen it depending on your needs. If the chain for ...Read moreyour chainsaw becomes too loose, it can come off the bar and cause injury, but if too tight can damage the bar or engine of the chainsaw. This assembly is installed on or near the clutch assembly of the chainsaw and is usually accessible by removing an access panel. Replacing this assembly is easy and only requires a wrench and screwdriver. First, disengage the chain brake and remove the screws securing the side panel of your chainsaw. Remove the side panel and locate the bar adjustment screw. Loosen the old adjustment screw and remove it and the tensioner pin. Thread the new adjustment screw through the new tensioner pin until the screw is locked into place. Then rotate the screw counterclockwise until the pin is in the middle of the screw. Replace the cover panel assembly and test the chainsaw.

This fuel cap is a genuine OEM replacement part manufactured by Homelite. It is compatible with over 130 models of chainsaws. This cap is made to seal the opening of the fuel tank to prevent leaks and contamination. It is made of plastic, and it should be replaced if it is damaged or missing. This part includes a retainer, which helps to ensure that the cap does not get lost. No tools are needed to replace it.

This item has been OEM sourced to ensure a high-quality standard. The rotor is intended to be used with trimmers, blowers, and chainsaws from Homelite and Ryobi. The rotor is the engine's flywheel and is used as one of the main components in the ignition sequence. The rotor has magnets on its edge that create an electric charge as they pa...Read moress the ignition module, this ignites the air/fuel mixture in the cylinder which rotates the crankshaft and the drive shaft. This item includes the pawls that make contact with the recoil starter pulley when the starter rope is pulled.

The hex nut attaches to the drive case cover. This part is made of metal and is sold individually even though many nuts may be needed during installation. This part may become stripped or lost and will need to be replaced. A wrench will be needed when replacing this part. It is an authentic OEM sourced item which is specially designed for use with Homelite and Ryobi chainsaws.

This genuine manufacturer-sourced component is made for use with Ryobi and Homelite chainsaws. It is an identical replacement for a missing or a faulty extension spring that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality spring is made of durable metal and is sold individually.

This is an authentic replacement part manufactured for use with chainsaws. The special front handle is used to provide a stable grip while operating the chainsaw. This front handle is sold as an individual replacement part, please see model diagram for associative parts.

A genuine item that is supplied directly from the original equipment manufacturer for use with Homelite and Ryobi chainsaws. It is a high-quality replacement for the shaft seal, make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Over time the material may wear out and begin to crack eventually requiring a replacement.

This genuine manufacturer-sourced replacement part is specially supplied for use with Homelite and Ryobi handheld lawn and garden equipment. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt, for correct application please refer to appropriate diagrams of your model. This high-quality lock nut is made of durable metal and it is sold individually.

This spark plug is an authentic Craftsman replacement part, and is compatible with chainsaws. The spark plug produces a spark that ignites the fuel in the engine. A socket wrench will be needed to install or replace the spark plug. This part is made of ceramic with metal and is sold individually.