My Orders
- Home
- RF267ACBPXAA
- Instructions
RF267ACBPXAA Samsung Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrigerator was too cold - down to 18 degrees Fahrenheit.
5 of 14 people
found this instruction helpful.
-
Bill from RALEIGH, NC
- Really Easy
- 30 - 60 mins
-
Screw drivers
Removed shelves. Removed back cover. Removed old sensor. Installed new sensor. Replaced back cover. Replaced shelves. Works fine.
Was this helpful?
Thank you for voting!
Door
1 of 2 people
found this instruction helpful.
-
Kathy from BUTTE, MT
- Really Easy
- Less than 15 mins
Replaced the spring on my French door refrigerator
Was super easy
Was super easy
Was this helpful?
Thank you for voting!
Brokjen spring
0 of 1 people
found this instruction helpful.
-
Sharol from Culdesac, ID
- Really Easy
- Less than 15 mins
Lifted out the broken part and replaced with new spring.
Was this helpful?
Thank you for voting!
french spring broke
0 of 2 people
found this instruction helpful.
-
RYAN from RIVERBANK, CA
- Really Easy
- Less than 15 mins
-
Pliers
after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell
Was this helpful?
Thank you for voting!
French spring broke.
6 of 26 people
found this instruction helpful.
-
Andrew from Bensalem, PA
- Very Easy
- Less than 15 mins
pushed new spring in.
Was this helpful?
Thank you for voting!
Not making ice. Making ice slowly. Clicking sound when making ice.
-
Gregory from North Richland Hills, TX
- Easy
- Less than 15 mins
-
Screw drivers
(1) Set ice production to OFF from the front panel of the refridgerator. (2) Inside the fridge, remove the screw holding the panel covering the cable for the ice naker assembly. (3) Remove the panel. (4) Disconnect the power cable of ice maker. (5) Holding the assembly with one hand, release the locking clip of assembly housing, and slide
... Read more
assembly forward until it is free. (6) Remove the ice maker assembly. (7) Install the new assembly by reversing the previous steps. (8) Reset the ice maker by pressing the reset button and holding it for at least 8 seconds. The first time the ice maker is primed with water, there are 2 chimes. (1 High , 1 Low).
Read less
Was this helpful?
Thank you for voting!