PDW8680JS General Electric Dishwasher - Parts

This part helps stop your dishwasher from leaking. This kit includes the impeller, seal, blade, filter, skidder and skidder holder.

This part is the upper spray arm for your dishwasher. It is made of gray plastic and is approximately 11 inches wide. The upper spray arm is mounted to the top of the dishwasher tub and rotates during the cycle to ensure that your dishes are washed evenly. If your spray arm is clogged or damaged, your dishes may not clean evenly, and you ...Read morewill need to replace the spray arm. To access the spray arm, you will need to remove the top dish rack, then simply unscrew the old arm. Screw the replacement arm in and replace the dish rack to complete the repair.

This works in conjunction with the pump and filtration system. It is used to filter the drainage for disposal.

This upper spray arm screw is a manufacturer-approved replacement part for your dishwasher. The spray arm is an integral part of the dishwashing process, so keeping it maintained is crucial. To replace this screw, remove the upper dishrack by popping out the dishrack stops on each side. Pull out the dishrack and use a 1/4 inch nut driver to unscrew the upper spray arm screw.

This leveling leg is located under the dishwasher cabinet. It is sold individually.

This part is the replacement latch handle for your dishwasher. It is made of black plastic and is approximately 5 inches by 1 inch. The latch handle is what allows you to open and lock the dishwasher door. If the latch handle is broken, you may not be able to open the door properly, and if the dishwasher door doesn't lock properly, the di...Read moreshwasher will not be able to run. The main reason to replace the latch handle is if it is cracked or broken. This part is sold individually and is an OEM part from the manufacturer.

Used to hold the tine row or combs in place on the dishwasher rack. *** Sold Individually.

This part is the replacement retainer handle for your dishwasher. It is made of black plastic and is approximately 5 ½ inches long and 2 inches wide. The handle retainer attaches to the handle of your dishwasher and holds the door closed during operation. If your dishwasher experiences a door latch failure, you may need to replace the ret...Read moreainer handle. Be sure to disconnect your dishwasher from the power source before you begin this repair. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

This drain hose is an OEM, manufacturer-approved replacement part for your dishwasher. The drain hose filters out the wastewater from the dishwasher. If there is a hole in it, water will leak out of your dishwasher. Shut off the water and power to the unit before beginning this repair. Accessing the drain hose involves unscrewing the dish...Read morewasher and pulling it out. Remove the clamp holding the hose in place to its connection under the sink, using a 5/16ths socket. Disconnect the fill line. Use a 1/4 inch nut driver to loosen the clamp at the other end of the drain hose. Keep a towel handy for any water still inside. Keep the clamps for use on your new drain hose. Reinstall all hoses and lines in reverse order.