PDW8200NB General Electric Dishwasher - Parts

This upper spray arm screw is a manufacturer-approved replacement part for your dishwasher. The spray arm is an integral part of the dishwashing process, so keeping it maintained is crucial. To replace this screw, remove the upper dishrack by popping out the dishrack stops on each side. Pull out the dishrack and use a 1/4 inch nut driver to unscrew the upper spray arm screw.

This leveling leg is located under the dishwasher cabinet. It is sold individually.

This part is the replacement retainer handle for your dishwasher. It is made of black plastic and is approximately 5 ½ inches long and 2 inches wide. The handle retainer attaches to the handle of your dishwasher and holds the door closed during operation. If your dishwasher experiences a door latch failure, you may need to replace the ret...Read moreainer handle. Be sure to disconnect your dishwasher from the power source before you begin this repair. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

This support is for the middle spray arm.

This is a 10 foot long conversion drain hose used with tall tub models.

This slide is mounted to each side of the upper cabinet wall. The dishrack wheels roll inside this track, which guides the upper rack.

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

This dishwasher conduit assembly directs the water to the upper spray arm.

Size: 10-32 GXTT FLP .595 Sold individually.