GTWN4950L0WS General Electric Washer - Parts

This is the start/stop button for your washer. If your washer will not start after the button is depressed, you may need to replace it. However, you may also want to check your door switch, because when the washer will not start, the door switch is often the issue. This part is made of rubber and is gray in color. It is a little bigger than 1 inch in diameter and is sold individually.

Sold individually.

This part helps center and support the drum, transmission and motor assembly.

This part is the replacement pressure switch, also known as the water-level pressure switch, for your washer. It is round and red on one side, and white with gold terminals on the other. The pressure switch senses and controls the water level in the washer. Once the washer has filled up to the appropriate level, it will allow the washer t...Read moreo move forward in the wash cycle. If it is defective, your washer will either not fill with water, or will not stop filling with water. Before you do this repair, be sure to disconnect your water from the power source, as well as the water source. This part is sold individually and is an OEM part from the manufacturer.

The triple water valve or inlet valve in your washer connects to the water source and solenoid wires, and ensures the tub has the right amount of water entering it. If your washing machine continues to fill after it is full, or if it fills slowly, you may need to replace this valve. Before you begin this repair, be sure to disconnect the water and power sources from your washer. This part is sold individually.

This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

This screw is sold individually.

This part is for the hose to outer tub.