GTWN4250D0WS General Electric Washer - Parts

1 - 12 of 99

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
DAMPENING STRAP 2PACK – Part Number: WH01X39337
No Longer Available
DAMPENING STRAP 2PACK
★★★★★
★★★★★
(9)
Part #WH01X39337
The tub dampening straps support the wash tub and reduce vibration by keeping the tub at the center of the cabinet. If your washer shakes and moves, or is making a loud banging noise during the wash cycle, the washing machine tub could be off-balance, meaning one or more of these straps may be loose, or broken. Other symptoms include: the washer leaking, not agitating, or pumping but not spinning. These straps are sold individually. However, we recommend that you replace all 4 straps at the same time. It is also recommended that you check the tub for cracks where these straps mount.
Tub Seal – Part Number: WH02X10383
$27.58
Special Order
Tub Seal
★★★★★
★★★★★
(4)
Part #WH02X10383
The main tub seal is located between the transmission and the outer tub. It's the primary water seal in the outer tub for the transmission-shaft. This seal is difficult to replace and should probably be installed by a qualified technician.
Dual Action Agitator – Part Number: WH43X10034
$142.92
Special Order
Dual Action Agitator
★★★★★
★★★★★
(21)
Part #WH43X10034
This does not come with the fabric dispenser - must order separately or use original part.
Tub Bearing – Part Number: WH2X1198
$47.16
Special Order
Tub Bearing
★★★★★
★★★★★
(4)
Part #WH2X1198
This tub bearing goes in your washing machine. You will find it on the bottom of the outer tub, where the transmission goes through the tub. If you hear metal on metal when the washer is spinning, you may need to replace the tub bearing. This bearing is made of metal, and is approximately 3 inches wide and 2 inches tall.
Tub Bearing Washer – Part Number: WH2X1197
$13.95
Special Order
Tub Bearing Washer
Part #WH2X1197
Split Ring – Part Number: WH02X10265
No Longer Available
Split Ring
Part #WH02X10265
This split ring is two inches in diameter.
Drain Hose – Part Number: WH41X10096
$79.66
Special Order
Drain Hose
★★★★★
★★★★★
(4)
Part #WH41X10096
This drain hose is a replacement part for your top-loading washer. The hose measures 57 inches in length.
6-Rib Drive Belt – Part Number: WH01X10302
$49.38
Special Order
6-Rib Drive Belt
★★★★★
★★★★★
(4)
Part #WH01X10302
This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.
Lid Switch with Wire Harness – Part Number: WH12X10334
$73.00
Special Order
Lid Switch with Wire Harness
★★★★★
★★★★★
(4)
Part #WH12X10334
The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed.
Agitator Coupling – Part Number: WH43X10032
$92.82
Special Order
Agitator Coupling
★★★★★
★★★★★
(5)
Part #WH43X10032
Bolt not included. This part connects the transmission drive shaft to the agitator base.
Drain Pump – Part Number: WH23X10043
$164.22
Special Order
Drain Pump
★★★★★
★★★★★
(11)
Part #WH23X10043
This replacement drain pump is designed to efficiently remove water from your washing machine during the draining cycle. Encased in durable gray plastic, it measures approximately 9 inches in height, 6 inches in length, and 4 inches in thickness. If your washer isn’t draining properly, is leaking, or the pump isn’t spinning, this component may need to be replaced. Installation typically requires basic tools such as a screwdriver and wrench. Always disconnect power before beginning any repair.
Water Pressure Switch Hose – Part Number: WH41X365
$26.58
Special Order
Water Pressure Switch Hose
Part #WH41X365
This is a water pressure switch hose, also known as the air dome tube, for your washer. It is made of clear plastic and is sold individually. The hose transports water to your water pressure switch, so the switch can control how much water enters the washer during a cycle. If your washer will not fill up with water, or if water continues to fill the tub even after it is full, you may have a damaged water pressure switch hose. Inspect the hose for cracks and leaks, and if the hose is damaged you will need to replace it.
1 - 12 of 99