GTW460ASJ6WW General Electric Washer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The washer agitator/auger broke off of the base during a wash cycle. The small plastic clips broke off the auger so it couldn't be put back on the base.
The agitator/auger was easy to replace - it just snapped into place. We watched a YouTube to make sure to lock it into the counter clockwise direction.
This saved lots of time and the cost of a repair person to come.
This saved lots of time and the cost of a repair person to come.
Parts Used:
-
Debbie from Kalispell, MT
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replaced GE Washer lid
Removed parts from old lid (bumpers, switch component and hinges), removed old lid, then replaced parts on new lid. The new lid fit perfectly and looks great.
Parts Used:
-
William from Naples, FL
-
Difficulty Level:Very Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Washer not spinning out completely.
1) Unplug washer
2) Remove water supply hoses
3) Remove drain hose
4) Tilt washer forward
5) Remove 4 bolts covering the motor assembly to access belt.
6) Remove old belt by turning it off the pullies.
7) The new belt needed to be stretched by attaching one end of the belt to one of the pullies using a zip tie. I did this by drilling a small hole in the larger pulley, large enough to allow the zip tie to pass through.
8) After tightening the zip tie to the belt, slowly turn the larger pulley to stretch the belt on to the smaller pulley.
9) Make sure belt is properly seated on both pullies.
10) Reinstall the cover.
11) Reattach drain hose and supply hoses.
12) Plug washer back in.
2) Remove water supply hoses
3) Remove drain hose
4) Tilt washer forward
5) Remove 4 bolts covering the motor assembly to access belt.
6) Remove old belt by turning it off the pullies.
7) The new belt needed to be stretched by attaching one end of the belt to one of the pullies using a zip tie. I did this by drilling a small hole in the larger pulley, large enough to allow the zip tie to pass through.
8) After tightening the zip tie to the belt, slowly turn the larger pulley to stretch the belt on to the smaller pulley.
9) Make sure belt is properly seated on both pullies.
10) Reinstall the cover.
11) Reattach drain hose and supply hoses.
12) Plug washer back in.
Parts Used:
-
Jeremy from JOHNSTOWN, NY
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Socket set
2 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Lid was forced open and broke latch
Follow the super simple, precise instructions and it is very easy. Only harder part was unclipping the front of the lid.
Parts Used:
-
Chris from LARGO, FL
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!