GT1928PAGW Maytag Refrigerator - Instructions

Removed old ejector arm and installed new part.

I removed the ice catcher from the excellent packaging, rinsed it, and placed it on the counter next to the fridge. I opened the door the the freezer and placed the ice catcher under the icemaker. I lowered the arm on the icemaker and closed the door to the freezer. Then I opened the door to fridge, took out a Guinness, popped the top, and sat down to savor my success.

removed shelf, removed sllides and replaced

hit the old rail a couple of time with a screwdriver to loosen it. Put the new rail on. Put the slide tape in the grove on the rail. Tooks the old wheel of the old rail and put it on the new one. Done!

I had a heck of a time getting the broken rail off the drawer. I had to pry quite a bit with a screwdriver to get it to slide off. Other than that, it was like falling off a log.

There was three screws to remove to unmout the ice maker, and unplug the wire harness,then two to remove to slip in new stripper. All took about 20 mins.

I matched up the holes on the shelf with the notches on the rail and snapped it into place. The only thing that was harder that weekend was watching golf and drinking beer. That took me four hours.

bulbs were not burnt out. received the new switch in a few days. watch the short video, was good to see how it comes out. used a putty knife to release the defective switch, removed wires put them on the new one and posed the new switch back in. Not bad Part cost $11.00 7 dollars shipping so for 17 bucks it works great. nice to see what is inside the refer!

Eased the putty knife under the edge of the switch housing and pried it off. Pulled two wires off the old terminals and hooked them onto the new one and reinstalled into the refrigerator body.

I removed the old one and replaced with the new one. The right side one was quite easy whereas the left one took a longer time.

We looked up the problem online with the model number of the refrigerator. We ordered the part and followed the video installation that was sent with the order and was found online prior to purchasing

I just popped out the old switch with a flat head screwdriver. Removed the connections and then installed new switch by reversing steps. Popped in back in and the light went on.

Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!

This was a simple "clip-on" job. With functioning plasctic hooks, the retaining bar clipped right on the door.

I took off the old retainer bar and snapped the new one in place. Easy.