GRSS2652AF1 Frigidaire Refrigerator - Instructions

Consulted You Tube. Took off old gasket. Easy. Put on new one after getting it warm. The track on the new gasket did not sit properly. Took multiple attempts but finally worked. Size was perfect but the gasket color was different than original and therefore, different from the refrigerator door. No tools required.

I looked at the internet before I purchased a new seal and saw how to repair it. It was a matter of pulling out the old seal and just popping in the new. The internet said to use a hair dryer to melt the rubber to adhere to the fridge in places where it wasn't. It was quick!

Twist to remove the old one an twist to install the new 9ne

The repair instructions were suspiciously easy sounding- but in actuality- right on! I am not a DIY-er , but I did it! The old gasket came off fairly easily and the new one went right on! No tools needed! There wasn’t an immediate ‘suction/seal’ when I closed the door, but Grok said that was normal, it may take a little time… Sure enough- in the morning it was tight! That’s been 2 weeks and so far- so good!

Just place new filter and lock it!

This barely qualifies as an installation. I simply lifted and pulled the old Deli cover out and placed the new one in place and snapped it down! I didn't need to use even ONE screw!
The easiest replacement ever!

Removed exterior housing, sliding old unit forward to release. New unit went in easily. Caution wires don't get pinched.

The gaskets aren’t really attached, they are just wedged into a small notch the goes around the entire door. So you can just pull the old one off with no tool. The new one arrived looking very bent and twisted but if you heat it with a hair dryer it goes back to its shape. When installing…You start in the corner and work your way around with a butter knife and hair dryer and it eventually sits into the notch. We watched a video on YouTube, it was easy to find a video and easy to do with two people and no tools or experience. Takes a few days for the gasket to feel fully settled into the notch

I first ordered the wrong switch I called and got a return label and was refunded my money before even shipping the wrong switch I was helped for the right switch and it arrived in 5 days the replacement works perfectly very easy to install. Thank you

Pulled door seal put and pushed in new seal, icing formed on fridge side lower return vents, had to fully chip away, compressor running and stopping as normal.

I had to tap the screw holes with a 8/32 tap so that the screws would not bind.

I had no problems. Screws arrived sooner than expected. It was a very simple installation. Very pleased with both the product and service.

When reading instructions, I noticed it said to run water through the water filter. I don’t have a water dispenser ~ I only occasionally make ice. So how often should I change, Barely used. The red light will go on, can I just ignore it?

Used socket set and screw drivers to attach ordered hinge, thankfully we had the screws just not the hinge. Wonderful to be able to find and order on line! Thanks so much!!!

pulled the old seals off one at a time and starting from the top of each door, pressed the top edge of the seal into the groove, using the quik clamps to hold the top in palce at each top corner, went down each side of the door and pressed the seal into the groove, when I reached the bottom, I moved the clamps to the bottom and used thm to help press the seal into the bottom groove, Each door took about 15 min.