GH4155XPS2 Whirlpool Microwave - Instructions

Took out the turntable parts to ensure I ordered the correct cooking tray. Matching those with photos of related parts on PartSelect worked great. Put turntable drive and support ring in place and cooking tray went in very easily. Plan to order a second one to have on hand for this rental property.

The most difficult part was getting the old screw out of the top of the grille. Once that was accomplished, the rest was easy as can be. I would highly recommend your service - very good! Thank you!

Placed to new grille on the microwave and attached
with the screws.

removed old vent and replaced by snapping in and two screws inserted into right and left top connections.

Ordered a new motor. Removed the outside trim of the oven-microwave combo. 2 screws at the bottom of the trim. Removed the screws that held the combination micro and oven unit in place. Removed the top and bottom black plastic grill of the microwave. 3 screws each. Pulled the entire unit out about 1 inch exposing the screws at each side of the microwave that hold it in place.
Snapped off the top control panel which exposed the wiring connecting the control panel.
Unplugged a couple of wire harness units to free the control panel.
Be sure to label the units to know which goes where during reassembly.
Remove the microwave unit from the housing and place it on its side.
Remove the metal plate that houses the motor. 4 screws hold the motor in place. Disconnect the 2 wires from the old motor and you are ready to install the new motor. Be sure to TURN OFF THE POWER to the unit at the breaker box and remove the turntable from inside the microwave.

Unscrewed glass panel, removed old bulb, cleaned glass panel and installed new bulb. Screwed panel back into place.

Used hands to slide filters sideways, till they could be pried out with screwdriver or bare hands. When new parts arrived, easily slide new filters into position. In hindsight, we did not need to replace grease filter. I was able to clean one of those with ordinary dish soap, warm water, and a brush.

replaced with new one

submitted manufacturer info to website and voila! a new glass turntable arrived in 2 days. I don't do well with computers, my 23 yr. old daughter was impressed......couldn't be easier! thanx! will definitely revisit your site

All I had to do was open the microwave door and place the turntable on the designated grooves, wha lah it fit. I am now back in business. Thanks to partselect, I found my replacement, ordered and it was shipped in no time.

I place the vent in the opening, put the screws in place, tightened the screws and viola.

put the turntable in and had a Rum and Coke to celebrate. Your service was GREATTTTTT...

Replacement part was perfect and a quarter the price of the brand name grill. Snapped it in, tightened 2 screws, done! Also delivery of the part was almost overnight. You guys are the greatest.

Glass plate arrived in less than two days. Placed the glass plate in Microwave and presto the microwave works like a charm.

Fitted the grille in place and tightened the screws to hold in place.