GFSS6KKYCSS General Electric Refrigerator - Instructions

Just put it in the holes on both sides only problem is the printing on cover is up side down

We received the part just a few days after ordering, unscrewed the old filter by hand, and installed the new filter the same way.

Pulled off the evaporator cover and replaced the Temp sensor.

exactly as the instructions.......never did see anything about replacing the adapter...therefore i did not

Disconnect power to refrigerator, Removed all upper shelving, slid the draw assemblies out 12 inches to gain access to lower retaining screws using my power screwdriver. Removed three lower retaining screws and two screws that hold the center shelf rail. Then removed the cover assembly by pulling out and down from the bottom of the assembly until I could access the connectors for the fan at the upper left hand corner. After releasing the lock tabs for the electrical connectors I removed the assembly from the refrigerator cabinet. There was an excessive amount of ice/frost buildup due to the fan failing so I used a blow dryer set on low to thaw the ice from the evap coils and related wiring and sensors. Once thawed and free from ice, I reversed the procedure to install the new cover. The procedure would have only taken about 10 minutes if it were not for the ice buildup. I would recommend letting the frig thaw first if you have another place to store the food. Overall, very easy to install.

The repair was so easy. I had to take out all the food. Then I was able to easily lift the shelf out, and put the new shelf in and replace the vegetable drawers.

Very easy, unscrew and re-screw new filter in..