GFSS6KKYCSS General Electric Refrigerator - Instructions

replaced the filter with the new one i purchased

pushed new spring in.

The repair was so easy. I had to take out all the food. Then I was able to easily lift the shelf out, and put the new shelf in and replace the vegetable drawers.

Disconnect power to refrigerator, Removed all upper shelving, slid the draw assemblies out 12 inches to gain access to lower retaining screws using my power screwdriver. Removed three lower retaining screws and two screws that hold the center shelf rail. Then removed the cover assembly by pulling out and down from the bottom of the assemb ... Read more ly until I could access the connectors for the fan at the upper left hand corner. After releasing the lock tabs for the electrical connectors I removed the assembly from the refrigerator cabinet. There was an excessive amount of ice/frost buildup due to the fan failing so I used a blow dryer set on low to thaw the ice from the evap coils and related wiring and sensors. Once thawed and free from ice, I reversed the procedure to install the new cover. The procedure would have only taken about 10 minutes if it were not for the ice buildup. I would recommend letting the frig thaw first if you have another place to store the food. Overall, very easy to install.

Easy, with included video and instructions

We received the part just a few days after ordering, unscrewed the old filter by hand, and installed the new filter the same way.

Removed the old filter. Filled the new one with water and put it in theplace of an old one. Flushed the system with 1 gallon of water.

easy slide out and put new one

Very easy, unscrew and re-screw new filter in..

Remove drawers and internal shelf supported by rail(no tools). Remove rail (phillips). Remove roller from existing rail. Intall roller on new rail. Install new rail (phillips). Replace shelf and drawers. Note: New roller (identified as a separate part) and screws are not included with rail.

Just put it in the holes on both sides only problem is the printing on cover is up side down

unscrew filter and replace the new one

none required

I took a small straight screw driver and popped the cap case off, removed old hinge and installed new hinge and snapped the cap back in place.. took all of 30 seconds

Installed new spring pin and spring. Took only 2-3 minutes. It was more difficult to get the correct part since the spring pin was the only number listed in the part diagram and I actually needed the spring and had to call customer service to get the correct part number.