FN200 (Type 1) Porter Cable Nailer - Parts

This authentic item is supplied directly from the original manufacturer for use with Porter Cable nailers. It is a special valve that helps to operate the trigger. This item provides an identical replacement for a faulty or a missing trigger valve that was installed on a new unit. Check the diagrams of your specific model for the exact lo...Read morecation and the correct installation of this component. Note, this high-quality valve is made of durable metal and is sold individually.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. Of the many causes for O-Ring failure, the most common are: • Extrusion and Nibbling - O-ring has ragged, tattered edges. These are com...Read moremonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

This genuine item is supplied directly from the original equipment manufacturer for use with Porter Cable nailers and staplers. It is an identical replacement for a missing or a faulty spring that was installed on a new unit. The purpose of this spring is to apply tension on the plunger, please make sure to refer to the appropriate diagra...Read morems of your model for the correct location and application of this part. Keep in mind this high-quality spring is made of durable metal and is sold individually.

It is a genuine item that is supplied by the original equipment manufacturer for use with Porter Cable nailers and staplers. The plunger attaches to the plunger spring and is made of metal. A wrench and a set of pliers may be helpful when replacing this part. It might break over time and will need replacing. This item is priced as an individual replacement part.

An authentic OEM sourced replacement part which is specially designed for use with Porter Cable nailers and staplers. The purpose of this part is to provide an air-tight seal between components, over time it may wear out and begin to crack eventually requiring a replacement. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware.