Models > FGID2466QF4A > Instructions

FGID2466QF4A Frigidaire Dishwasher - Instructions

All Instructions for the FGID2466QF4A
346 - 354 of 354
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Lost several wheels from lower rack of dischwasher
Nothing to it. Just inserted the iron stud into the center wheel and pressed the bracket onto the stud.
Parts Used:
WHEEL & BUSHING ASS
  • Peter from Houston, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Rat chewed thru the drain HO9SE
pULLED THE WASHER FROM THE COUNTER disconjnected the house from the garbage disposal connected thenew hose to the disposal, remove other end of old hose from thedishwasher and replace with the new drainage hose.
Parts Used:
Dishwasher Drain Hose
  • Mahlon from Kirby, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The upper spray arm fell off and separated.
Replaced arm with new one received in one day from PartSelect. Quick and easy, just screw new one on. Perfect!
Parts Used:
Upper Spray Arm
  • Fred from Johnstown, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
No waste water discharged from dishwasher
Open door, remove 2 screws from underside of countertop. Close door, remove screws from bottom kick panel,( 2 piece, set aside). Slide dishwasher out, to gain access to left side. (disconnect water line, drain line, and power, if not enough slack). Carefully remove 2 wire clips from discharge pump (located directly behind main motor). Remove screws (3) from pump housing. carefully pull out old pump. Check and clean pump mounting area. Push new pump into opening, do not force. turn to line up screw holes, insert screws, and tighten. install wire clips as removed ( white on left) . If needed, reinstall water line, drain line, and power. Slide dishwasher back into opening. Run a rinse cycle, and check for leaks. If good, install screws into countertop, and install kick panel.
Parts Used:
Drain Pump -120V 60Hz
  • Thomas from South Amherst, OH
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Spray Arm Fell Off
Unscrew old screw on new
Parts Used:
Upper Spray Arm
  • Al from cottage grove, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
upper spray arm fell offunscre
unscrew upper spray arm assembly, screw in new unit. Finished
Parts Used:
Upper Spray Arm
  • salvatore di from Oldsmar, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Dishwasher leaking
Removed old gasket,placed new one on pressing into place.Very quick and easy.Saw the youtube on how to do it.Unfortunately this was not the problem.now have a new dishwasher same brand.
Parts Used:
Dishwasher Tub Gasket - Gray
  • Lauren from Marietta, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Dishwasher leaking from underneath unit
Spotted the source of the leak at the first heating element under the dishwasher. Removed the brass mounting nut and it was cracked. Replaced with new part from PartSelect.com and the leak was fixed. Apparently the heating element gets so hot it tends to crack the mounting nuts, which results in a leak. Delivery time for part said 3-5 days - mine arrived one day after ordered!
Parts Used:
Heating Element Brass Nut
  • Keith from Meansville, GA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Wrench set
Was this instruction helpful to you?
Thank you for voting!
upper spray arm falls 0ff
the part was shipped really fast and was a perfect match for the old part. super happy with the results. thank you partselect
Parts Used:
Upper Spray Arm
  • randell from manchester, TN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FGID2466QF4A
346 - 354 of 354