FDB4315LFC3 Frigidaire Dishwasher - Parts

This gasket goes on the bottom of the dishwasher door to create a tight seal between the tub and the outer edge of the door. If the gasket is cracked or broken, it will need to be replaced to keep water from leaking out on to the floor. The gasket is approximately 23” long and is a genuine OEM part. It is recommended that once you have in...Read morestalled the gasket to leave the door closed for a few hours to make sure the gasket is properly sealed.

This dishwasher water inlet valve is a genuine OEM component designed to regulate water flow into the appliance during the fill cycle. Typically located behind the lower kickplate panel in either front corner, the valve uses solenoids to open and close, ensuring the correct amount of water enters the tub for effective cleaning. Operating ...Read moreat 120 volts and 60 Hz, this part is essential for maintaining proper dishwasher performance. Common symptoms of a faulty valve include leaking, failure to fill, poor cleaning results, or incomplete draining. Installation requires disconnecting power and water supply, and a flat blade screwdriver may be needed to access the valve. Always verify model compatibility before purchase.

The upper spray arm helps distribute water from the top of the dishwasher tub.This spray arm is a genuine OEM replacement part for your dishwasher. This spray arm is for the upper part of your dishwasher. No tools are required for this repair, simple remove the rack stops and upper dish rack, then disassemble the mount and spray arm before installing the new one.

This is a basket for washing flatware or silverware in your dishwasher.

The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, or you notice that your dishwasher is not cleaning dishes properly, you may need to replace the rack wheel. The single rack roller kit is mad...Read moree of white plastic, and clips to the dishwasher rack with the included axle/clip. Many of our customers have described this repair as easy, and you will not require any tools to complete it. Lower rack roller and bracket assembly, grey. Wheel has been updated. If wheel pictured is not like old one, you may need to replace all wheels.

This is installed at the bottom corners of the door seal.

This part is a replacement spray arm support for your dishwasher. It is made of white plastic and is approximately 3 inches long, 1 inch wide, and 3 inches tall. This is the support for the lower spray arm and is found at the bottom of the dishwasher. The lower spray arm spins on the support when the dishwasher is running. If the support ...Read moreis cracked or broken, the spray arm may not spin, and your dishes will not be cleaned properly. You may also notice that your dishwasher is noisy when it runs; this can mean the arm support is damaged as well.

If your dishwasher won’t start or the door won’t close properly, the latch assembly might need replacing. This part helps keep the door securely shut and includes a switch that stops the dishwasher from running when the door is open. It’s easy to install, but make sure to unplug your dishwasher before starting the repair for safety.

This nut is sold individually. It is used to install the heating element.

The drain hose connects to the pump located below the lower spray arm. It aids in proper dishwasher drainage. Size: 7.5 feet long

Sold individually.

This plastic cover and stem assembly helps hold the lower spray arm in place.