FDB4315LFC3 Frigidaire Dishwasher - Overview

Diagrams for FDB4315LFC3

See every part. Know exactly what you need.

Parts for the FDB4315LFC3

$49.59

Dishwasher Bottom Door Gasket

★★★★★

(233)

Part #809006501

This gasket goes on the bottom of the dishwasher door to create a tight seal between the tub and the outer edge of the door. If the gasket is cracked or broken, it will need to be replaced to keep water from leaking out on to the floor. The gasket is approximately 23” long and is a genuine OEM part. It is recommended that once you have in...Read more

Read less

$40.65

Water Inlet Valve - 120V 60Hz

★★★★★

(79)

Part #154637401

This dishwasher water inlet valve is a genuine OEM component designed to regulate water flow into the appliance during the fill cycle. Typically located behind the lower kickplate panel in either front corner, the valve uses solenoids to open and close, ensuring the correct amount of water enters the tub for effective cleaning. Operating ...Read more

Read less

$43.95

Upper Spray Arm

★★★★★

(42)

Part #5304506516

The upper spray arm helps distribute water from the top of the dishwasher tub.This spray arm is a genuine OEM replacement part for your dishwasher. This spray arm is for the upper part of your dishwasher. No tools are required for this repair, simple remove the rack stops and upper dish rack, then disassemble the mount and spray arm before installing the new one.

$40.57

Silverware Basket

★★★★★

(52)

Part #5304535382

This is a basket for washing flatware or silverware in your dishwasher.

$14.14

Wheel & Bushing Assembly

★★★★★

(11)

Part #5304532229

The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, or you notice that your dishwasher is not cleaning dishes properly, you may need to replace the rack wheel. The single rack roller kit is mad...Read more

Read less

$39.55

Splash Shield Kit

★★★★★

(9)

Part #154701001

This is installed at the bottom corners of the door seal.

$18.95

SUPPORT

★★★★★

(18)

Part #5304532235

This part is a replacement spray arm support for your dishwasher. It is made of white plastic and is approximately 3 inches long, 1 inch wide, and 3 inches tall. This is the support for the lower spray arm and is found at the bottom of the dishwasher. The lower spray arm spins on the support when the dishwasher is running. If the support ...Read more

Read less

$53.32

Latch

★★★★★

(36)

Part #5304525218

If your dishwasher won’t start or the door won’t close properly, the latch assembly might need replacing. This part helps keep the door securely shut and includes a switch that stops the dishwasher from running when the door is open. It’s easy to install, but make sure to unplug your dishwasher before starting the repair for safety.

$19.95

Heating Element Brass Nut

★★★★★

(8)

Part #154106202

This nut is sold individually. It is used to install the heating element.

$49.96

Dishwasher Drain Hose

★★★★★

(8)

Part #807117001

The drain hose connects to the pump located below the lower spray arm. It aids in proper dishwasher drainage. Size: 7.5 feet long

$58.25

Door Spring

★★★★★

(26)

Part #154579101

Sold individually.

$39.21

Lower Spray Arm Support

★★★★★

(18)

Part #807145201

This plastic cover and stem assembly helps hold the lower spray arm in place.

Manuals & Care Guides for FDB4315LFC3

Click to download

Install

Installation Instructions

(1.06MB)

Install

Installation Instructions

Questions And Answers for FDB4315LFC3

Ask our experts a question about this model and we'll get back to you as soon as possible!

Sort by:

Joel - For model number FDB4315LFC3

May 22, 2025

keep getting a ' pf' code . It happens at various time during the cycle. Mainly after the cycle is complete and sometimes during the cycle. Thanks for help.We hope this sorts out your problem!

Hi Joel, thank you for contacting us. The 'PF' code on your dishwasher typically stands for "Power Failure." This code indicates that the dishwasher has detected a power interruption during its operation. Ensure that the dishwasher is properly plugged in and that there are no loose connections. If you have a circuit breaker, check to see if it has tripped and reset it if necessary. If that is not the issue, the control board may be faulty, and you may need to replace it. The part number is PS12365809. We hope this solves your problem!

$247.70

Electronic Control Board

Was this helpful?

Common Symptoms of the FDB4315LFC3

How this model fails, and the parts that fix it.

Leaking

Fixed by
these parts

Show All

Not cleaning dishes properly

Fixed by
these parts

Show All

Will not fill with water

Not drying dishes properly

Will not dispense detergent

Fixed by
these parts

Show All

Videos related to models starting with FDB4315LFC3

Watch our pros, then fix it yourself.

Replacing the Dishwasher Bottom Door Gasket

Replacing the Water Inlet Valve - 120V 60Hz

Replacing the Splash Shield Kit

Replacing the Heating Element Brass Nut

Replacing the Door Spring

Replacing the Dishwasher Drain Hose

Replacing the Upper Spray Arm

Replacing the Drain Pump

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

The spray arm would fall off during the washing cycle.

827 of 844 people found this instruction helpful.

Roy from Worcester, MA
Really Easy
Less than 15 mins

Repair was simple. I unscrewed the old grommet which held the old spray arm and screwed-on the new one. About 30 seconds was required. Other people having this problem should note that the spray-arm is made of three pieces which are inseparable when the arm is new. The arm is sold in this form. However, when your machine is having th ... Read more

Read less

Was this helpful?

Water leaking from Inlet Valve

623 of 640 people found this instruction helpful.

CHRIS from ROANOKE, VA
Easy
30 - 60 mins
Nutdriver, Pliers, Screw drivers, Socket set, Wrench set

Remove the bottom cover plate. Disconnect the water inlet and black rubber hose. Remove 2 mounting screws. Pull out electrical connector. Reverse order. Be sure to get the brass inlet connector really tight so it won't leak. I did the final tightning after the part is mounted. Not a bad repair at all. The only problem was that it ... Read more

Read less

Other Parts Used: