DW708 (Type 1) DeWALT Miter Saw - Parts

This is an authentic manufacturer-supplied part which is designed for DeWALT miter saws. It is a special hardware which is utilized to provide a tight fit between connected components. Please make sure to refer to the appropriate diagrams for your model for the correct location and application of this thrust washer. This high-quality part is made of durable metal and is sold as an individual item.

This genuine Dewalt screw is a high quality item specially designed for use with miter saws. This special piece of hardware has a few different applications depending on your tool. Please make sure to check appropriate diagrams for correct location and applications of this item. Note, this part is sold individually. You will need a torx screwdriver or a flat-head screwdriver to install or remove this screw.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling...Read moreu> - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

Read less