DW708 (Type 1) DeWALT Miter Saw - Parts

This is an authentic DeWalt replacement part manufactured for use with miter saws. The torsion spring fits into the trunion where the saw head pivots. This spring returns the saw head to its upright position after it has been lowered. The spring can wear out over time and may need to be replaced in order to safely operate the saw. This torsion spring is sold as an individual replacement part.

This authentic manufacturer-sourced component is specially made for use with DeWALT compound miter saws. It is an identical replacement for a missing or a faulty foot that was installed on a new unit. The part helps to support the unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and applic...Read moreation of this hardware. Keep in mind this high-quality foot is made of durable rubber and is sold individually.

This is a genuine DeWalt replacement part that has been sourced from the original manufacturer to be used with miter saws. The wear plate is used to provide spacing between the base and the table. This item is used to allow the table to swivel without damaging the base. This item is priced as a single part.

This is an original part from DeWalt. The miter pointer is made for use with several miter saw devices. Often fastened to the table assembly, the plastic item is designed to assist the operator to make accurate cuts. It is recommended to refer to the specific manual and diagrams for repair instructions. The miter pointer is sold individually, and a screwdriver is required for the installation.

This part is an OEM from DeWalt. The base fence is made for use with several miter saws, and is sold individually. This metal component is fitted onto the table assembly, allowing the operator to make accurate cuts to the project material. A screwdriver is needed to make the installation. The fence is priced as a single item.

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with miter saws. The metal pulley key is used to link a rotating shaft and a pulley to allow the two parts to rotate in unison. This pulley key is priced as a single item.

This shoulder screw is an original part from DeWalt. The metal screw is compatible with miter saws, and is sold individually. The screw is often used to secure the pawl to the table. A screwdriver is required for the removal and installation. It is recommended to purchase a spare, as they can wear over time and regular use.

This is an authentic DeWalt replacement part manufactured for use with miter saws. The pivot sleeve is used to support the guard spring inside the guard. This pivot sleeve is sold as an individual replacement part, please see model diagram for associative parts.