1. Home
  2. 917279100
  3. Instructions

917279100 Craftsman - Instructions

All Instructions for the 917279100
1 - 3 of 3

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Wheel bushings were bad
29 of 48 people found this instruction helpful.
  • Anthony from OLIVEHILL, TN
  • Easy
  • 15 - 30 mins
  • Pliers, Screw drivers
Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat other side.
Read less
Was this helpful?
Thank you for voting!
Lound deck noise when mower put into motion
4 of 16 people found this instruction helpful.
  • Steven from Hickory, NC
  • Easy
  • Less than 15 mins
  • Socket set, Wrench set
Parked mower on level concrete drive, laid on cardboard. Lowered mower deck all the way. Sparayed some WD40 on nut/bolt on top of old pulley. Since it is a carriage type bolt, placed 5/8" boxed end wrench over self locking nut on top of old pulley. Using some force from 3lb mallet to break nut free (hitting against wrench body), the nut c ame off easy as did broken pulley/bearing inside. Installed new pulley assembly, re-tightened nut on bolt. Checked after first mowing just to be certain pulley was in place and locking nut tight.
Read less
Was this helpful?
Thank you for voting!
Front wheels, too much end play
10 of 39 people found this instruction helpful.
  • Frederick from BINGHAMTON, NY
  • Very Easy
  • Less than 15 mins
Shimmed the wheels out on axle.. No more slop.
Was this helpful?
Thank you for voting!
All Instructions for the 917279100
1 - 3 of 3