6651574991 Kenmore Dishwasher - Instructions

removed old seal, placed new seal in place. Used my fingers to push it in place. It didn't work as it still leaks. I've put vaseline on the seal and door and it helps but still leaks. The dishwasher doesn't overfill, so I still have the problem, just not as bad.

one screw held the switch in place and is located at the front left of the machine at the bottom access panel, the new part was exactly as the old, the wires pulled off easy and plugged in to the new with no problem, switch still makes a noise and did not fix the problem, my fault not yours. Timer is moving thru the cycle but machine does no run or water flow in.

First I removed the the rubber sides. Then I slide the replacement panel over the exisiting one. That's it no other tools were needed. I didn't even break a sweat.

Removed back plastic panel ( 6 screws) from front steel facing( beauty panel). Pulled and put aside back interior plastic panel affixed to beauty panel. Front steel panel still in place. Removed cover plate on back of remaining beauty panel protecting electrical components affixed with plastic keepers ,with a screwdriver. I then yanked old timer and replaced with the new one. Cake walk, since the original timer and the new one had all the leads in one plastic fitting. Thanks for you help! Hope this account aids someone else!

Part arrived in 48 hours. Had to pry apart the two piece assembly of the damaged item. Snapped the replacement in place and fastened it to chassis with two machine screws

Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!

I removed the cardboard insert, put the new front panel on and replaced the tabs. That was it!

pulled the old door seal off and pushed the new seal into place and it works great!
THANK YOU!

1-2-3 EASIEST JOB I EVER HAD to DO AND THE WIFE IS PROUD OF ME FINALLY.

THANKS , , ,Bat from WEST SENECA (Buffalo, NY)

pulled out the old gasket, aligned and pressed in the new gasket

I opened the door and pulled the gasket from around the dishwasher. The gasket does not have any adhesive around it, so it pulled free almost immediately. The new gasket was pressed into place around the door and I was done. It couldn't have been any easier. I suspected it was the gasket when I saw pinched portions that did not return to the original shape and there were no visible cracks in the machine.

Lowered door and put a weight on it to keep it open. with screwdriver pried out the old gasket. It was simple. looked at the end of the replacement gasket and inserted it into the track with the small hole down. Job Complete. about three minutes total time.

This was an easy fix. My husband took out the old gasket and put the new one in. It fit perfectly and no more leak. The part got to us really quickly too and that was nice. No more hand washing the dishes! :)

Remove retainer that holds door color slide in front of door & then remove the slide. Remove cardboard backing, remove electric latch release, remove latch & replace with new one. Open door & slide out the cup dispenser cover pin & spring & replace with new ones. This was all straight-forward & simple.

Replaced heating element and high limit thermostat. Was suppose to fix the problem but did not. Replaced the control board and works now. All of these are easy to replace.