580752382 Craftsman Pressure Washer - Parts

This is an authentic OEM part for use with Briggs and Stratton Pressure Washers. The chemical injection connector connects the chemical injector to the pump. This part is sold individually. The most common reasons for replacing the injector kit are when water is getting into the soap dispenser, the chemical injector nozzle is leaking, or ...Read morethe pressure washer soap injector is not working at all. The tools that you will need to replace the chemical injector are pinch-off pliers, 13mm wrench, and a flathead screwdriver.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with pressure washers from Briggs & Stratton and Troy-Bilt. The hardware is used to attach the motor to the frame assembly. The kit includes rubber isolators that absorb engine vibration. This kit is sold complete with all the parts that are in the photo.

This is a genuine Briggs and Stratton and Troy-Bilt part for use with Pressure Washers. The unloader valve kit includes the parts needed to replace the unloader valve, which opens to relieve water pressure and recirculate water through the pump when the spray wand isn't in use and the pressure washer is running. The most common reason for...Read more replacing the unloader valve kit is if it is damaged. The tools that you will need to replace the unloader valve is a screwdriver, pliers and a Wrench Set.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually requiring replacements. Refer to the appropriate diagrams for your model to ensure the correct replacement procedure. A screwdriver and a wr...Read moreench set might be needed to take apart and reassemble the equipment. Note, this kit is sold as an individual item.