My Orders
580752382 Craftsman Pressure Washer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The foward motor mounts both failed allowing the entire engine and pump to swing back
1 of 2 people
found this instruction helpful.
-
Edward from BANGOR, PA
- Really Easy
- Less than 15 mins
-
Wrench set
I loosened the rear motor mounts which protrude through slots in the frame using a 15mm open end allowing the engine to be moved enough to pass the front mounts through both the frame and the engine mounting holes. The upper bolts on the front mounts don't have enough clearance for a socket or box end and the open end gets less than a qua
... Read more
rter turn at a time unless you remove the wheels. I just took my time and tightened the nuts being careful not to round the corners. The lower bolt/nuts present no problem.
Read less
Was this helpful?
Thank you for voting!
Supplied hose has "press on" fitting on one end, washer does not accommodate it
2 of 6 people
found this instruction helpful.
-
Anthony from RIDGEFIELD, CT
- Very Easy
- Less than 15 mins
One can either pull off the plastic fitting on one end (the one with an o-ring) and press the plastic tubing onto the pressure washer detergent inlet (located just behind the high pressure hose outlet/connector). The other end of the device is then inserted into a jug of pressure washer detergent and the lowest pressure nozzle or nozzle
... Read more
setting selected to allow detergent to be drawn up into the washwater stream with the pressure washer running. One can observe the detergent flowing into the washer if all is good! If one cannot pull off the plastic fitting on one end (the other fitting, to be left!, has a "screen" on its end - the fitting can be cut off the plastic tubing with a utility knife.
Read less
Was this helpful?
Thank you for voting!