41791122311 Kenmore Dryer - Parts

This part helps keep the door closed while the machine is running.

If your dryer drum has stopped spinning and your clothes are coming out damp, it might be time to replace the belt. This essential part helps the drum rotate, allowing warm air to circulate and dry your laundry properly. Made from sturdy material, it’s built to last but can wear out with frequent use. Replacing it is a manageable DIY proj...Read moreect—just grab a screwdriver and wrench to access the belt and swap it out. This part is sold individually, so you’ll only need one to get your dryer running smoothly again.

"Male" piece of a dryer door closing mechanism.

Sold Individually.

This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating. This part is located in the blower housing.

This ignition coil kit contains two coils. One is a two wire secondary coil, while the other is a three wire booster coil. Both should be used together in your gas clothes dryer.

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

This is a gasket, but you may also know it as a door seal, for your dryer. This part prevents heat loss during a drying cycle by keeping the area around the door sealed. This gasket is all black, and is made of extremely flexible material. The surface of this part is roughly half an inch wide, and a quarter inch thick. One side of the mat...Read moreerial is smooth, while the other side has clips to make your installation easier.

This switch is for a dryer door with a drum light.

This dryer thermal fuse is a critical safety component designed to protect the appliance from overheating. It automatically shuts off power to the motor or heating system if excessive temperatures are detected, helping prevent damage or potential fire hazards. Once the fuse is triggered, it cannot be reset and must be replaced. A faulty t...Read morehermal fuse may cause the dryer not to start, run without heat, shut off prematurely, or operate at unsafe temperatures. Replacing this component helps restore safe and proper dryer operation.

Sold individually.

This dryer lint screen grille cover is a precision-molded component designed to fit securely within the lint screen housing. Its primary function is to prevent small clothing items from slipping into the lint duct while supporting the lint filter’s performance. By acting as a barrier it helps reduce the risk of clogging in the exhaust sys...Read moretem and promotes consistent airflow which is essential for efficient drying and preventing overheating. The grille cover also contributes to the overall safety and longevity of the appliance by minimizing the chance of debris entering the vent system. Installation typically involves placing the cover inside the lint screen compartment ensuring it aligns properly with the housing for optimal function.