40-690 (Type 1) Delta Scroll Saw - Parts

This is an authentic replacement part sourced directly from the manufacturer. The pivot rod is found in scroll saws from DeWALT and Delta. This part is made of metal, and is used to hold the vertical rocker assembly between the left and right housings, allowing it to pivot with the motion of the drive links. You may require an Allen wr...Read moreench or hex key when replacing this item. The pivot rod is available as an individual replacement part.

This is an authentic DeWALT and Delta replacement part that is sourced from the original manufacturer for use with scroll saws. The sleeve bearing attaches to the lid and is made of metal. When replacing this item a screwdriver might be required during the installation process. It may become broken and will need to be replaced. This item is priced as an individual replacement part.

This tension cam helps maintain proper blade tension on a scroll saw, ensuring smooth, accurate cutting performance. It’s designed for select saw models and allows the blade to be tightened or adjusted with ease, helping keep cuts clean and consistent. If the saw blade won’t stay properly tensioned, slips during use, or becomes difficult ...Read moreto adjust, replacing the cam can restore reliable operation. Availability may vary for older saw models, so it’s often considered a specialty replacement part.

This is an authentic replacement part, sourced from the original manufacturer for use with scroll saws. The special rubber bellow is used to push air through the air pump and through the air nozzle. This bellow is available as an individual replacement part, please see model diagram for associative parts.

The air pump cap attaches to the air nozzle and is made of metal. This item is available as an individual replacement part. It is a genuine replacement part sourced from the original manufacturer for use with saws made by DeWALT and Delta. A screwdriver and a wrench might be required during the replacement of this item. Over time it may break and will need to be replaced.

This is a genuine OEM sourced replacement part that is intended to be used with scroll saws from DeWalt and Delta. The metal bar attaches to the top rocker mount and is used to support the foot that protects the blade. The bar will require a torx driver and hex driver to install, and the bar is priced as a single item.

This part is guaranteed OEM, made to fit the DeWALT and Delta scroll saws listed below. This hold down foot is attached to the top mount via the black bar. Note that mounting/adjustment screw is sold separately. This foot is sold individually. Associated parts: • Top Mount, part # 286277-00 • Bar, part # 286291-00 • Screw, part # 286316-00