3612 - Parts

This is an authentic OEM part. The Makita compression spring 7 is made for use with several router and grinder devices. The metal spring is often fitted in the motor bracket, providing tension to the pin. This component is sold individually. Please refer to the specific manual for repair instructions. No tools should be necessary for making the installation.

The compression spring connects to the pin. It is made of metal and is sold individually. This is an OEM part sourced directly from the manufacturer and used in Makita saws. A set of pliers might be necessary during the installation of this item. This part will need to be replaced if it breaks or bends.

This is an authentic replacement part sourced directly from the manufacturer. The insulation washer is found in Makita power tools such as chainsaws, grinders, and demolition hammers. This part is made of high-quality plastic, and is placed between the armature assembly and the ball bearing. You may require a screwdriver when replacing...Read more this item. It is advisable when removing multiple parts to keep careful track of their order so they can be reassembled correctly. The insulation washer is available as an individual replacement part.

This rubber piece is a genuine Makita manufactured part. It is manufactured for various power tools. A cord protector guards the wires from damage caused by motion and strain. Damaged cords must be replaced to avoid safety hazards. A replacement cord is sold separately. This item consists of one (1) cord protector. This is a simple and qu...Read moreick repair. • Unplug machine • Remove the casing • Detach cord from tool • Slide cord protector onto cord • Reattach wires and casing • Test power tool

This cord guard / strain reliever is a genuine Makita replacement part. It covers the final portion of cord before entering the tool, providing extra rigidness and preventing cord damage. Over time these cord guards break down and require replacement. The guard is constructed of heavy duty rubber compound for toughness. This cord guar...Read mored is compatible with the tools listed below. It is not guaranteed to fit any other power tool models.

This is a genuine OEM sourced replacement part which is specially designed for use with Makita power tools. The purpose of this strain relief is to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. Keep in mind it is made of durable rubber and is sold individually.

This is a genuine Makita replacement part that has been sourced from the original manufacturer to used with miter saws, sanders, routers, table saws, chop saws, circular saws, demolition hammers, and reciprocating saws. The plastic strain relief is used to secure the power cord within the housing near the switch. This item is sold as an individual replacement part.

It is an authentic OEM sourced replacement collet cone, it is specially produced for use with Makita routers. This part is the component that secured router bit in a tool. It is made of high-quality metal and it is sold individually. This collet cone is for using bits with 1/2" arbors only, please note the collet nut is sold separately.

This replacement collet nut is sourced directly from the original equipment manufacturer for use with Makita routers. It provides an identical replacement for a missing or damaged component that came with the new tool, the purpose of this part is to secure the collet which holds the bit. Please note this high-quality part is made of durable metal and is sold individually.

This is a genuine OEM sourced replacement collet insert adapter specially designed for use with Makita routers. This part will allow for use of 1/4" bits. Due to prolonged, heavy use a collet adapter may begin to wear out requiring replacement. It is made out of metal and is sold individually. To replace this item you will need a wrench....Read more • First you would need to remove the collet nut • Once the nut is removed you can remove the old collet adapter • Place a new one in place • Tighten the collet nut back in place and your unit is ready to use 1/4" bits