34-607 (Type 1) Delta Table Saw - Parts

This replacement belt is specially manufactured for use on Delta power tools. It is a genuine item that is sourced directly from original equipment manufacturer. It is commonly used as the main drive belt on band/table saws and drill presses. This belt is made out of rubber material and it is sold individually. You would need a screwdriv...Read moreer to complete a repair. • Remove the belt cover • Replace the old belt with the new one • Secure the housing

This cap screw is a genuine Delta replacement part that is supplied from original equipment manufacturer for use with power equipment. It is a standard hardware which has multiple uses depending on your model, please make sure to check appropriate diagrams for correct use and location of this hardware. Note this durable metal cap screw is sold individually.

This see thru guard is supplied from original manufacturer for use with Delta saws. This part helps to direct dust and trimmings away from the user. This will help to keep the work area clean as well as provide protection from the blade while unit is in operation. It is made out of clear plastic and it is sold individually. Please note th...Read moree hardware and bracket are both sold separately. To replace this guard you would need pliers.

The pivot bracket attaches to the see thru guard. This item is available as an individual replacement part. This is a genuine replacement part sourced from the original manufacturer for use with table saws made by Delta. A set of pliers may be necessary during the installation of this item. It is made of metal and will need to be replaced if it breaks.

This high-quality spring is designed for use with Delta saws. It is supplied by the original equipment manufacturer. The spring applies tension on the kickback finger allowing it to retract. Over time it may wear out and lose tension eventually requiring a replacement. It is made of high-quality metal and is sold as an individual componen...Read moret. Make sure to check the diagrams of your model for the exact location and the correct installation of this spring. You will need a screwdriver to remove the push pin that holds the old spring.

This is an authentic replacement part manufactured for use with Delta table saws and unisaws. The push nut is commonly used to secure a pin to a part assembly. This push nut is used with several different models of saws and can have multiple applications. The push nut is sold as an individual replacement part, please see model diagram for associative parts.

This Ball Bearing is sealed on both sides. This genuine Delta replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on ...Read morethe tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

It is an authentic part that is supplied by the original equipment manufacturer for Delta saws. This is an identical replacement for a missing or faulty pin that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality pin is made of durable metal and is sold individually.

This pulley cover is a genuine OEM replacement part sourced directly from Delta. It is commonly used in table and contractors saws. This plastic part provides a cover for the pulley. This cover should be replaced if it is cracked or broken. No tools are required to replace it. With steady hands, remove the wing nut that secures the cover. Replace with the new cover and secure the wing nut again.

This is an authentic Delta replacement part manufactured for use with drill presses, table saws, sanders, and band saws. The special set screw is designed to sit flush with the outer wall of a part assembly. This set screw has multiple applications depending on the model of the power tool, please see model diagram for part location and usage. The set screw is available as an individual replacement part.