34-607 (Type 1) Delta Table Saw - Parts

This is an original Delta replacement part manufactured for use with drill presses and table saws. The special hex nut has multiple applications depending on the model drill press or table saw. This hex nut is sold as an individual replacement part, please see model diagram for part location and usage.

This special nut is priced individually and fits next to the lock washer. It is made out of metal and will need to be replaced if it becomes stripped or broken. A wrench will be needed during the installation of this part. The nut is an authentic part from Delta to be used in drill presses.

Genuine Delta replacement part, this item is sold individually. The purpose of the is nut is to secure the blade of the Table Saw to the Saw Arbor. It is a left hand ACME thread. It is used on all of the right tilting Table Saws listed below.

This is a genuine manufacturer sourced replacement part used on Delta and Black and Decker equipment. It helps to distribute the pressure evenly and provide a tight seal between connected components. This is a standard hardware which may have multiple applications. For the exact location please refer to the diagrams of your specific model. This part is made of high-quality metal and is sold individually.

This is a genuine manufacturer-sourced replacement part which is specially designed for use with Delta drill presses. It helps to distribute the pressure evenly while allowing parts to be secured safely. This is a standard hardware which has multiple applications based on your equipment. Please make sure to refer to the appropriate diagra...Read morems of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This metal pin helps hold and align the blade guard or splitter pivot on a table saw. A loose, crooked, or hard-to-move guard may mean the pin is bent, broken, or missing. Before replacing it, inspect the pivot bracket, mounting holes, clips, and nearby hardware for wear. Confirm fit with the complete saw model, type number, and parts dia...Read moregram as there are multiple pins located in the units. Unplug the saw and lower the blade before service. Install the pin in the position shown, then make sure the guard moves freely and stays aligned before using the saw.

This is an authentic Delta replacement part, sourced from the original manufacturer for use with band saws, drill presses, lathes, table saws, and jointers. The metal key is used to shaft and rotating gear or pulley to allow the two parts to rotate in unison. This item is available as an individual replacement part.

This is a genuine manufacturer-sourced replacement part which is designed for use with Delta saws. It is an identical replacement for a missing or faulty spring that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This is an authentic replacement part manufactured for use with Delta arbor saws and table saws. The load spring is commonly used to provide spacing between the arbor bearing and the arbor flange. This load spring is available as an individual replacement part, please see model diagram for associative parts.